Odometer reset does not reset mileage. no movement.

There is no fuse for just the odometer, has main fuses for the whole instrument cluster . Odometer not working? instrument cluster problem. Have it checked by a professional repair shop.

Odometers
Each instrument panel cluster (IPC) is equipped with a season odometer and 2 trip odometers. The IPC uses the odometer rolling count message from the powertrain control module (PCM). The rolling count value is determined by counting the speed pulses from the vehicle speed signal (VSS). The IPC uses the rolling count data from the PCM and a software program to determine vehicle mileage. The odometers can be displayed in miles or kilometers. The units displayed is switched between English and metric by pressing the menu button on the driver information center (DIC) until the units mode is displayed. Pressing the set/reset button will select between English or Metric. . When the set/reset button is pressed to show the odometer in metric, km and the number will be displayed. When the odometer is in English, MI and the number will be displayed.


Season Odometer
The season odometer displays the total accumulated miles or kilometers of the vehicle. This value is permanently stored in the IPC. If an odometer malfunction occurs or if the IPC must be replaced, an authorized Delco service center must be contacted to program proper vehicle specifics, including mileage, for the IPC. The season odometer is capable of displaying 999,999 kilometers or 999,999 miles depending on units selected. Leading zeros are not displayed. The display will not roll-over to 000,000 if the maximum displayed miles or kilometers are reached. If the display limit is exceeded, the maximum value (999,999) is displayed. If the mileage is above 621,503 miles and metric units are selected the odometer shall display 999,999 km.


Circuit/System Testing
Ignition OFF, raise the vehicles drive wheels.
Engine ON, transmission in drive, verify the scan tool Vehicle Speed Sensor parameter matches the speedometer display.
? If the Vehicle Speed Sensor parameter does not match the speedometer display, replace the IPC.
Verify that the odometer is operating properly.
? If the odometer is not operating properly, replace the IPC.

Odometer
The odometer is an electronic digital display. Digits displayed are illuminated by the odometer backlight bulb. The odometer backlight bulb brightness is controlled by class 2 messages from the BCM to adjust the display for daylight and instrument panel dimming operation. The trip odometer and total odometer will show in this display area. The push button in the lower right side of the speedometer is used to toggle between the trip and total odometer readings. To reset the trip odometer, push and hold the button down for at least two seconds. The total odometer display has six digits with no decimal display. The trip odometer has four digits including a decimal point and indicates tenths of a mile or kilometer.
The body control module (BCM) stores the vehicle mileage. If the BCM fails, the cluster will display the last valid mileage that was sent before the BCM failed. For replacement of the BCM refer to the BCM section of this service manual. Replacement instrument clusters do not require odometer pre-setting before installation. If the instrument cluster is replaced, the mileage stored in the BCM will be sent to the new cluster via serial data, and shown in the odometer display.

Your best bet , take it to a qualified repair shop.

How many miles are on this vehicle? I ask because the odometers in these car stop working around the 140k to 170k mark. Did the button comeback? Is this the mileage on the digital or analog trip meter?
The process to change the odometer gear is fairly straight forward and takes less than $20 and an hour. Let me know.

push odometer button until the mileage is shown, turn key off, now hold in the button in while turning key on (dont start engine) keep holding button in and the odometer will have dashes, it will count down until the dashes go away, now light is reset.

push trip odometer button so that the mileage is displayed. hold in trip odometer button, keep holding in while turning key on, keep holding until you see the dashes on the display count down and disappear. the oil change light is now reset.

my mother in law's 2005 Toyota Camry to turn off the maintenance light after an oil change. push and hold the trip/odometer and turn the ignition key to the run position while still holding trip/ odometer switch and release trip/ odometer tun ignition switch off and light should be reset

reset: turn ignition on...push odometer button till it displays mileage on car...not trip milage but actual mileage. Turn car off. Open driver's door, press and hold odometer button....turn ignition to on....hold odometer button for 10 seconds....odometer display will show -----,----,---,--,-,0000000....maintenance lights are reset...lights will come on every 7500 miles to remind you to change oil and check fluids etec....

You will need to pull the speedometer out and have the odometer (u call mileage counter) repaired, the little drive gear that comes off the speedometer to operate the odometer has failed or broken.

The negative number means the car should have had it's oil changed that many miles ago. Oil life starts at 100% for new oil & counts down every 10%. At 15% the display will always show, which means it's near time to change the oil.

usersteve83, your oil may have been changed but the timer not reset. Reset the timer as shown...
1. Turn ignition to the "ON" position. (do not start engine)
2. Press SEL/RESET repeatedly until the oil life indicator is displayed.
3. Press & hold the SEL/RESET for about 10 seconds until it blinks then let go of the button.
4. Press the SEL/RESET again for about 5 seconds or until the oil life indicator resets to 100%.

Wrench = Maintenance Minder: Symbol letter & number...
Symbol A - Relace engine oil.
Symbol B - Replace engine oil & filter, Inspect front & rear brakes, Check parking brake adjustment, Visually inpest the tie rods, suspension components,driveshaft boots, brake hoses & line (including ABS), all fluid levels & their conditions, exhaust system, fuel lines & connections.
Symbol 1 - Rotate tires.
Symbol 2 - Replace air cleaner element (dusty conditions every 15K miles) & replace dust & pollen filter (behind glovebox) every 15K miles if mainly dusty or city driving.
Symbol 3 - Replace transmission fluid.
Symbol 4 - Replace spark plugs.
Symbol 5 - Replace engine coolant.

All above are taken from the 2006 Civic EX owner's manual.

I own a dealership, and you are NOT stuck taking it to a dealer.

This is how you do it:

1. Turn the key on
2. Verify that the ODO dislays your 59+K miles; NOT trip A or trip B; you MUST see "ODO" displayed
3. Turn the key OFF
4. Push in and HOLD the trip reset button. Do NOT release it until advised...
5. Turn the key to the "ON" position, do NOT start the car.
6. Obsrve the odometer. You will see 5 dashes, then 4, 3, 2, 1 dashes, and then 5 zeros
7. The mileage you started with will return.
8. Release the trip reset button.
9. Start the car verify that the light is out.

If thi does not work, and it should, please get back to me.