SOURCE: 1992 honda accord spark plugs and wire
chilton or haynes manual will give you all this and every thing else you need for your vehicle
SOURCE: 1992 HONDA ACCORD WILL CRANK BUT NOT START
No spark is uasually caused by a faulty coil or the trigger unit,both are inside the distributor. Get a used distributor fron a scrap yard (about $4o) and replace yours.Remove the dis.cap and turn the engine until the rotor is pointing to fire # 1 cyclinder,and mark the exact position of the base before removing from the block." Do not turn the engine" Install the other Dist. with the base in exactly the same position and the rotor pointing exactly to # 1 cyclinder. Note. Failing to install the other dist.exactly the way you took the first one out will throw the timing out!!!!!
Be doing all of this be sure there is no spark.
Naz
SOURCE: 1992 Honda Accord LX won't start - ignition problems
you have to replace the main relay located inside the car, its located underneath the cruise control module, on the drivers side
SOURCE: 1996 Honda Accord Rough Idle Even After tune up
Perform a valve clearance inspection and adjust if necessary. Tight or sticking valves will cause a misfire or rough running concern. Note: Perform valve adjustment when the engine is stone cold. 4cyl: INT 0.26mm EXH: 0.30mm (V6 engine are hydraulic and no adjust necessary.) Also check for a sticking or stuck open EGR valve. For diagnostic purposes only: Remove the EGR valve. Place a business card over the EGR passage and bolt the EGR valve back on. This plugs the EGR ports and if the misfire goes away the EGR valve is partially stuck open and is defective.
Check for low fuel pressure. Check for low compression. Check cam timing. Check for a weak ignition coil. Also don't over look the possibility of worn or broken engine mounts which cause excessive engine movement and engine vibration. -hope this helps
56 views
Usually answered in minutes!
×