97 gtp turns over wont start..fuel pump runs enermidintly

Here's a link to where it's located. Engine Control Unit .Here's something else I ran into for you to read. Engine Control Module ECM can fail Pontiac Grand Prix Exhaust and Emissions

No.
The only pump that will work in a GTP model is the pump for that model. And there are more than one tag number for the GTP.
Flow rates can be anything between 20 and 60 GPM.
You have to match the tag code for your car.

spray your maps sensor with sensor flued only they sell it at your autoparts store

check your fuel filters, fuel line, and fuel pump

bad fuel pump.- just replace it and your good to go!

Hello! You're symptoms sound very much like a common problem associated with the fuel pump resistor. The GTP engine has a two speed fuel pump. There are two relays that control the fuel pump via the PCM module. The fuel pump relay and fuel pump hi-speed relay. Tied into the hi-speed relay is a fuel pump resistor that may go bad.

Symptoms vary but primarily the engine will start but die in a matter of seconds due to insufficient fuel pressure.

Here is a picture of the relay - which is located in the fuse box in the engine compartment:


What you can do to both diagnose this and either narrow it down to this or disqualify it as the culprit is remove relay #15, and bend out the tab labeled "85", and then reinstall the relay. If this does solve your problem, then you need to replace the Fuel Pump Resistor. Doing this will bypass the resistor, and place the fuel pump in "high" speed mode at all times. Once you have replaced the resistor, you need to bend the tab back to its normal position and replace the relay.
NOTE: while this may be a helpful diagnosis tool, and provide a temporary fix - doing this procedure for a prolonged period of time can lead to fuel pump failure. Use this at your own risk.


Hope this helps and good luck!

If you replaced the fuel pump then there is a possibility that during the job then some debris from the tank and/or filter got loose somewhere into the fuel system and is in your lines. It could even be a very tiny speck of gasket material, old or new.

If you have a GTP these engines use a hi output fuel pump. they use a fuel pump resistor located under the battery tray (look up from under the car) This resistor lowers the voltage to the fuel fump when not in boost mode. because of its locatoin it is prone to corrosion. if you bypass the wires and the engine starts and stays running replace the resistor

Known GTP problem.

You most likely have a bad fuel pump resistor, which controls 2 speeds of the fuel pump.

To check to see if this is the problem, there is a trick you can do and its very easy to do. Go to the attached link, and bend the tab my finger is pointing at and then plug it back in. If your car starts and runs fine, well we just solved the problem.

Link ->> http://www.boredandstupid.com/relay.jpg

check the fuel pump and lines. look for the fuel filter and see how much junk is in it.