1995 Chevrolet K1500 Logo

Related Topics:

A
Anonymous Posted on Nov 13, 2013

95 chevrolet silverado 4x4 abs code 12 22 37 67 66 68 73 86

My abs light is on and I abs cods 12 22 37 67 66 68 73 86 what are they

5 Related Answers

Philip Markert

  • 165 Answers
  • Posted on Jun 06, 2008

SOURCE: 2001 Chevrolet Silverado

Bad sensor in one wheel, they are part of the wheel bearing. Could also be a bad abs computer module, either way, not cheap.

Ad

mikehumble

  • 124 Answers
  • Posted on Dec 04, 2008

SOURCE: 2001 silverado 4x4 abs brake keeps coming on

in these trucks if the front abs activates at low speeds it is normally because of the wheel speed sensors in the front hubs. easy fix is to remove wheel speed sensor from wheel bearing. clean and file cast surface of bearing to allow sensor to move closer to internal reluctor ring. what happens is over time the casting rusts and creates a larger gap. please rate if this works.

rick_amick

Rick Amick

  • 73 Answers
  • Posted on Mar 30, 2009

SOURCE: 2005 Chevrolet Silverado 2500HD 4x4 Oil Change Reset

Not positive 05 is the same but on my 02 you turn the key to the on position and pump the gas pedal 4 times.

6bta

  • 400 Answers
  • Posted on Oct 20, 2009

SOURCE: abs codes co281 & co265

the first of the two codes is for the brake light switch, the one that is under the dash attached to the brake rod and brake peddle. Not much to diag on that one, if its bad it's bad, and when it sets the code that means it's bad.
The second one is for the abs modual, it's under the truck on the drivers side. It is bolted to the top of the thing that has all of the brake lines going to it. MOST all of the time that code is set the modual is bad. It can be a little hard to get the bolts out they are torqs 20 or 25(i'm getting old). There are four of them holding down the modual. There are also a couple of connectors going to it. And some of the time it will blow the fuse for the abs under the hood(its in the underhood fues block). Make sure to clean off the modual before you pull it out. You don't want dirt getting in the solinoids for the BPMV(that's the thing it's bolted to).

Anonymous

  • 1 Answer
  • Posted on Nov 20, 2009

SOURCE: 2005 chevrolet silverado 1500 4X4 service 4wd code

I wish I could help you with this as I have the same problem! Mine also shifts into 4WL sometimes at start. I replaced the switch assembly ($96) and it went away for a couple months and then returned.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Abslight stays on. How to fix? This is a2007trailblazer?

First you need to have EBCM - electronic brake control module check for DTC'S - diagnostic trouble code's . If the light is on there is a code stored . I think most part stores can do this and for free . After you find out what code is stored , looking up that code in service repair information for diagnostic trouble shooting chart would be next step . There are a few codes too.
DTC C0035 or C0040
DTC C0045 or C0050
DTC C0110
DTC C0131
DTC C0161
DTC C0186
DTC C0196
DTC C0201
DTC C0240
DTC C0241 or P0856
DTC C0244 or P1689
DTC C0245
DTC C0283
DTC C0287
DTC C0290 or C0292
DTC C0455
DTC C0550
DTC C0558

Find the code do the diagnostic's , fix the problem , wiring issue's , a sensor , bad module ,what ever it is . The light will go out then . Here is a sample of code discription .
• DTC C0035 Left Front Wheel Speed Sensor Circuit
• DTC C0040 Right Front Wheel Speed Sensor Circuit
0helpful
1answer

I have a 2004 silverado error code u1000 ,my 4x4 does'nt work and my abs and brake light is on

sounds like a wheel speed sensor.
or worst case a abs module.
is 4x4 electronic selection?
0helpful
1answer

I HAVE A 2004 SILVERADO AND ERROR CODE U1000 COMES ON 4X4 DOES`NT WORK ABS AND BRAKE LIGHT IS ON

  1. abs and brake light means u need fluid or u have a leak
  2. then 4x4 works not all trucks but 50% are like that
0helpful
1answer

My 2000 silverado z71 when switching to 2hi 4hi or 4lo the push button will flash and the front end will not ingage. and also have a abs light on

The 4x4 will not engage unless the ABS is in proper order the reason being. ABS cannot operate in a 4x4 engagement,and in return the 4x4 will not hi or low without the ABS concerns corrected the solution fix ABS and the 4x4 switch goes back to normal operations
0helpful
2answers

2006 chevy silverado abs light comes on goes off comes on goes off

Hi...your problem might be coming from your front wheel bearing hubs. They are know to cause this problem as they wear out and eventually have to be replaced.

http://www.autozone.com/autozone/parts/2006-Chevrolet-Silverado-3500-4WD/Wheel-Bearing-Hub-Assembly-Front/_/N-jnpe7Z8kns

If I helped...please rate me...thanks!
0helpful
1answer

My abs and brake light come on at the same time and stay on occasionally when I start my 2001 chevy silverado 4X4. If I turn the truck off and then restart it they will sometimes stay off.

Scan it,pull the codes when the lights come on and repair the ABS System. Most likely a Wheel Speed Sensor. Test all parts first,to determine if their bad. If you have no knowledge of these systems,take it to a shop.
0helpful
1answer

Brake pedal a.b.s pulsation at slow speeds on dry road.It wont do it all the time. It is on a 2000 chevy silverado 1500 4x4. I can hear the abs kick in when this happens.

You may see the abs light come on in your dash. I would plug a OBD II reader in and retrieve the codes.
I would say you either have a sensor that has gone bad or possibly a wire is shorting.
You can see the wheel sensor if you turn your wheels, and look down by the wheel hub bearing.
You can here the abs go whrrrrrrrr, when you step on the brake, and your braking flucuating.
Please let me know what you find.
0helpful
1answer

Abs codes 1995 silverado 4x4 kelsey-hayes

Both show as trans codes in my book. #73= Pressure Control Solenoid"If return amperage varies more than 0.16 amps from command amperage" and # 86 =Low Ratio, and this one has no definition. and they are listed under 96 disel W/4L80E and 94 gasW/4L60E.Well hope this helped.
0helpful
1answer

2003 silverado abs/brake light and service 4x4 light comes on heater blower quit working at the same time.

Possible bad ignition switch. Check out video on YouTube called 2003 Trailblazer, no blower, abs and brake lights on. I know it says trailblazer, but it applies to most of gm full size trucks. 2003-2007 including Silverado. Video tells you how to test to see if that is the problem.
Not finding what you are looking for?

828 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...