Cars & Trucks Logo

Related Topics:

T
Troy McDonald Posted on Nov 12, 2013

Chevy 2500HD Duramax 6.6 will turn over and start but dies after ten seconds

No issues with fuel system, just when it's cold the truck will start up and then die after 10-30 seconds. (Usually) Can be fixed by pumping the accelerator pedal while starting. Does this indicate a worn out accelerator sensor or something worse?

1 Answer

Sam Koussan

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

  • Contributor 9 Answers
  • Posted on Nov 12, 2013
Sam Koussan
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Joined: Nov 06, 2013
Answers
9
Questions
4
Helped
2095
Points
20

Take it to autozone and have them check your battery for recommended cold cranking amps and have them test your starter and alternator they do it all for free

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Oct 06, 2008

SOURCE: truck starts, dies. truck runs good some days,bad the next

I had the same problem with My 1990 F150 300 6cylinder 4x4.....I cahnged all the same things you did, finally I sprayed a can of Gumout through the throttle body and it worked and ran great. Now I add fuel injector cleaner to the gas and a regular clean with the gumout and the problem has'nt come back. Good Luck to you and hope it works!

Ad

Anonymous

  • 1 Answer
  • Posted on Dec 18, 2008

SOURCE: 2000 chevy blazer, truck cranks

Does your battery go dead?

Anonymous

  • 335 Answers
  • Posted on May 26, 2009

SOURCE: I Have a 2002 blazer that starts but motor dies, surges when accelerating

If this engine is a VORTEC then you may have a problem with the internal fuel system. Under the top plenum there is a fuel reg and poppet valves that inject fuel into the cylinders. Sometimes the tubes that run fuel from the reg to the valves can leak and cause your problem. This cannot be found with pressure check because this occurrs after the reg. PS fuel mileage will go down. Let me know if this helps.Moe

Anonymous

  • 97 Answers
  • Posted on Jul 08, 2009

SOURCE: 89 chevy truck misses and dies on acceleration

try the mass air flow sensor

Anonymous

  • 5 Answers
  • Posted on Feb 14, 2010

SOURCE: My Mazda mx3 starts up idles for a couple seconds then dies.

Before you replace the fuel pump, I would check the cheaiper parts first. Such as fuel filter and injectors.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

2003 GMC Sierra 2500HD LB7 Duramax. Can anyone help me figure out why my starter stop cranking after just a few seconds.

Question edited for clarity.
Question moved to model category.

Is your security light flashing? It sounds like the engine immobilizer is activated.


How do I reset my 2003 chevy silverado security system?

Vehicle History https://www.vehiclehistory.com > questions > how-do-...
Apr 9, 2020 - The first thing You need to do is open the driver's side door, and sit down inside. Next, place Your key in the ignition, and turn it to the on ...

6 answers · Top answer: Resetting the 2003 Chevrolet Silverado security system is easy, and takes about 5 to 10 minutes. The first thing You need to do is open the driver's side ...

How do I Reset the Theft Deterrent System "The Sequence?"

Diesel Place https://www.dieselplace.com > ... > Electrical
Dec 26, 2008 - Try This: · 1. Put the key into the keyway and turn it to the ON (RUN) position. · 2. Within 1 minute after the indicator light goes off, turn the ...

Gmc Sierra 1500: I need to reset the security on my 2004 gmc

JustAnswer https://www.justanswer.com > GMC Questions
Jan 10, 2013 - 30 minute GM relearn procedure: 1-Turn ON the ignition, with the engine OFF. 2-Attempt to start the engine, then release the key to ON ( ...

1 answer · Top answer: HI, What is happening - is the security light staying on and truck not starting, or is the ...

How do you reset the computer and or the passlock, anti

JustAnswer https://www.justanswer.com > Chevrolet Repair
Jan 4, 2010 - Bump the key into the start position then leave it in the on position for 10 minutes, after 10 minute shut vehicle off for 5 seconds and ...

1 answer · Top answer: Ok, let me know. Thanks

..
0helpful
1answer

I have a 2001 Chevy Silverado 2500HD duramax. It starts good cold, but when it's warm up,it is hard to start

check the fuel pump pressure, the normal pressure is 45-60 psi.compare the pressure when the car is cold and when its hot
0helpful
1answer

OBDII Codes 2006 Chevy 2500HD w/ 6.6L Duramax "Truck started losing power when warm, when cold for the first 10 miles or so the trunk runs great."

You need a dealer, there is a real problem going on here, way over the head of any home do it yourselfer. The main reason is the special tools required to interface with the control modules that are throwing these codes
0helpful
1answer

Started ran for a few seconds then stopped will not start again. It was just like turning the key off

You may have a fuel leak check fuel primer for leak ..getting air in fuel system
4helpful
2answers

2002 chevy 6.6 duramax wont start even in warm weather or after motor is warm..... only starts with starting fluid. codes are p0335/p0193/poo87/p0090

The Duramax fuel filter assembly is bad about sucking air. Replace the fuel filter assembly. It comes with a new fuel filter.
I need some good feedback.
6helpful
2answers

I have a 05 Chevy Duramax Diesel that is having issues starting. Randomly it will just not start. Turns over fine, but no start. Acts like it is out of fuel, but there is fuel. Let it sit a while,...

I am currently having the exact same problem with my '05 duramax. today for the first time it even died while driving and then would not restart for 5 minutes. If you figure this out please let me know. My email is [email protected]
Im taking mine back in to have it looked at tomorrow.
12helpful
2answers

On 2005 duramax injectors, is there a recall on this issue

05 duramax injectors have gone bad I'm told because the ecm has gone bad. Is this the case or I'm I being told a crock? They say it needs 4 injectors. While I was driving down the road it started missing and then it would quit and start missing again. After about 6 miles it died. After changing the fuel filter and priming the system it would not start unless assisted with gas vapor. It will run for a few seconds (20 or so) very rough with no power at all and then would die. Does Chevrolet have any recomendations or will they give any assistence with this problem. I don't think I'm the first person that has had injector problems with the Duramax .

Thanks
Mike
Wheeler
1helpful
1answer

Low fuel rail pressure

who did a conversion on this truck???? the duramax is a common rail engine and can not handle wvo or sve. it will destroy your entire fuel system in no time on this truck. if you want to do a vo conversion you need to get a diesel with an inline injection pump or one of the older powerstrokes. i would suggest you quit trying to run wvo through this truck if you do not want to do a lot of very expensive damage
Not finding what you are looking for?

663 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...