My power door locks have stopped working. Where is the fuse panel located on the 2000 GMC Safari?
SOURCE: 2000 GMC Sierra Power seat stopped working
check the wires behind the seat control on the side if the seat, sometimes the wires will get pinched and short to ground
SOURCE: 2000 Safari, power locks,Rear dutch door wont unlock,
can you use the key its self on the rear door. what i mean is not using the remote but actually using the key?
SOURCE: New gmc Safari '88, where is fuse panel?
There are 2. One inside under the Dash on the Drivers site and a Fuse Distribution Panel on the Drivers Side Under the Hood for Maxi Fuses and Relays.
SOURCE: 2000 GMC Safari anti-lock brakes
There was actually a recall for this. Go to your local GMdealer and have them check your VIN for a recall. If not under recall get out of there its easy to repair yourself don't let'em fool you.Remove the front pads caliper and rotors. Locate the abs sensor mounted to the wheelbearing assembly by a small socket head cap screw (Allen wrench). Removethe bolt and softly gently/wiggle the abs sensor around until it pops upout of the hole. some will break, which is why it wouldbe nice if the recall applies to your vehicle that way if they break gm replaces. Once you get both sides removed, clean themounting surface of all rust or build up with w-d 40 and small steel toothbrush then wipe off excess with clean rag and mild soap and warm water, dry completely make sure no spray residue exist on parts, Next apply a thin layer of lubricant grease to preventfuture rusting and reassemble.The rust build up under the sensor is causing the angle to change resultingin inaccurate wheel speed readings in the abs module your abs module will interprets this asa wheel is either slipping or skidding and applies your abs. This should make you happy with no more irritations. Please rate me. If you need further assistance you can always ask me. Good luck with this.
SOURCE: 1998 safari van - removal of passenger internal door panel
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. then you just remove the bolts to the mirror
2,244 views
Usually answered in minutes!
There's only a couple of relays in there my running lights stoped working all of them
×