I changed out the ballast it worked for 1 week then the headlight low beam stopped working again... any ideas??
Buy a two pack of the low beam bulbs and change both had lights. the voltage drop will burn one out since they have different resistance.
If you need further help, reach me via phone at https://www.6ya.com/expert/chris_b82b45c59bcf133d
SOURCE: 1990 525i bmw headlights
Check the wiring in the lights it may be poor construction or mis care that has madr a wire become looseand only rarely turn on
SOURCE: Low Beam Headlight
This is a bulb and is very easy to replace. You might want to buy a pair since other side will go out soon also. Simply twist connector behind light system, pull and replace bulb. good luck
SOURCE: burned out headlight/bulb bmw 1991 325i 2dr
It's a bulb replacement. If it's anything similar to my Audi, there is a cover on the back of the headlight housing that you pop off. Then you can reach in, pull the wire connector off the bulb, and unclip a metal retainer over the bulb, and pull the bulb out. Installation of the new one is the reverse. Just be SURE not to touch the glass part of the bulb. Skin oils can cause a halogen bulb to burn very hot and burn out very quickly. If you do touch the glass, wipe it gently but thoroughly on a cotton cloth to clean it off before you install it.
SOURCE: 2004 BMW X3 driver side low beam headlight
remove the air filter housing ,simple .this programme has a spell check thingy working and its driving me nuts ,it cant identify plain english ,write colour and it squiggles it out but color is ok .
replace bulbs newer models are double contacted, normally if a lot of vibration and knocking around occurs this could short out and have it blown, also you may want to chek for slack connection on the contacts for the bulbs, again a problem due to vibration
151 views
Usually answered in minutes!
×