P1260 is pre supply pressure monitoring, rate reduction due to low-pre-supply pressure. That is, fuel related. However, this normally triggers limp mode (<30mph/<2000RPM). Not uncommon on the X5. I would start with replacing fuel filter before delving into the lift pump/fuel delivery unit, in tank pump etc. Clear fault codes, run the car again then see what happens again - same fault codes?...then its delivery fuel pressure related. Should be 3.9bar at idle and not drop below 3.5bar.
SOURCE: saab 93 engine fault codes p1230 and p1260 ?
What? that's crazy! why wont you take advises from several mechanics? this is the best solution.
2,328 views
Usually answered in minutes!
×