Wind shield wipers will not work - 1992 Jeep Cherokee Sport

sounds like a wiper motor or might be a bad ground try to tap on the wiper motor with a hamer and is it starts to move you will need to replace it

No, thye should all be on separate fuses.

Wind shield wiper motor has to be replaced, Gears are slipping on it.

The wind shield wipers not working could mean either the wiper motor is faulty or the fuse, relay or switch in the steering column is faulty.

You will need an auto electrician to have a look.

this is normally caused by a bad wiper motor or binding of the wiper gears and linkage arms.
check to see if the linkage arms are tight and not loose. also try and lube up the pivot points.
another thing to check is to make sure you have 12 volts to the heater.

c...

right were the hood ends by the wind shield

IF YOU REPLACE SWITCH.IT HAS TO BE THE WIPER MOTOR UNIT.

Hi,

Take a look at the below mentioned link :-

http://www.diynetwork.com/diy/ab_talk2diy/article/0,,DIY_13696_3029974,00.html

You would be able to replace wind shield wiper motor by taking guidance from above link.
Thanks.

Sounds like a linkage (wiper transmission) problem. But, put an external ground wire to the wiper motor first and see if they work then.
Also many wipers have a fastening nut on the wiper arm where it attaches to the stub that goes through the body. These may have loosened and gone out of adjustment. If so, loosen them and re-position arms, then tighten them down.

i hope this video help you with your problem!