Question about Cars & Trucks
Can buy 02 parts fix 03 crv p1457 code
Check your evap cannister it might need the charcoal replaced
Posted on Nov 02, 2013
Testimonial: "It is no problem, can I use 02 parts to replace 03?"
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: P1457 - Honda Civic 2005 LX
this car come with tree diferent engines the answer i'm going to give you is for a 1.7 engine sohc that codes means you have a leak on the evaporative system this system monitor the vapors from fuel tank this code some time might appear for filling the fuel tank with car runing i recomend you to clear code and make sure the fuel cap is not loose because there is a fuel pressure sensor in the tank and if the sensor don't read the right pressure then it will set the code
Posted on Jun 01, 2008
SOURCE: HONDA CR-V
OK, you have a code PO341 which means their is a problem with the signal the ECU is receiving from the cam sensor. It does not necessarily mean the sensor is bad. It can be one of these things.
1. Cam sensor wiring routed too close to spark plug wiring (causing interference) 2. Poor wiring connection at cam sensor 3. Poor wiring connection at PCM 4. Bad cam sensor 5. Damaged reluctor wheel You replaced the cam sensor and the problem is still there so we can assume that a defective cam sensor was not the problem. Do this.
1. Check that the wiring isn't routed too close to any secondary ignition components (coil, spark plug wires, etc.) 2. Visually inspect the wiring at the sensor for any burn marks, discoloration indicative of melting or chafing 3. Visually inspect the reluctor wheel through the cam sensor port (if possible) for any missing teeth or any damage 4. If reluctor isn't visible from outside the engine, visual test can only be done by removing cam shaft or intake manifold (depending on engine design)
Posted on Aug 24, 2009
SOURCE: code P1457 for honda accord 2000
code p1457 is an evap leak code. a honda dealer can run a functions test on the system with the honda daig scan tool. but 90% of the time the probelm is the CVS valve. also known as canister vent shut valve. i've seen this a hundred times. its located under the rear of the car on the drivers side. its bolted to the evap canister with 2 (most likely rusted out) bolts.- hope this helps
Posted on Dec 12, 2009
there is either a problem with the wiring going to the front oxygen sensor, or with the oxygen sensor itself. good luck!
Posted on Mar 31, 2010
Testimonial: "Thanks - I'll have someone look into it!"
Tips for a great answer:
May 22, 2016 | 2003 Honda CR-V
Sep 19, 2014 | 1998 Honda Accord
Apr 06, 2013 | 2003 Honda CR-V
Feb 09, 2013 | Cars & Trucks
Jan 23, 2013 | Cars & Trucks
Jul 19, 2017 | 2002 Honda Accord
Jul 09, 2010 | 2002 Honda CR-V
Jul 22, 2008 | 2002 Honda CR-V
278 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: