Key will not turn to lock position & can not be removed
SOURCE: ignition switch
if the car has tilt wheel sometimes it cheaper to replace the whole steering column and have it rekey for you key at a locksmith call around at a good salvage yard and try to find one the same color as your and if you can not find one here is a place that sells only GM parts Schram auto & truck parts the # is 1-800-292-1032
SOURCE: Ignition Lock cylinder set removal
Then you either got the wrong bolt, or the knob part is still in the hole. Take a close look at the bolt you took out, and see if something may have broken off it. If it did, you might be able to get the rest out with a magnet. There is a threadless part on the end of the bolt that's about an inch long. It goes down against the tumbler and hold it in there. The newer ones are a torx head, but i can't remember if 78 is or not.
SOURCE: How do you replace the ignition lock cylinder for
the steering wheel will need to be pulled off the remover the directional switch about three inches out of the way
then you can remove the retaining screw that holds the cylinder in place
SOURCE: wheel is not in locked
The ignition cylinder has to be removed by tool, its called pin punch.The pin punch is a small pin that pushes against a release tab underneath the cylinder lock.--------- Before that steering column cover has to be removed.------ For complete procedure, click the link below:--- http://howtobyme.blogspot.com/2011/07/how-to-remove-ignition-lock-cylinder-on.html ---------- This will help.Thanks.Helpmech.
128 views
Usually answered in minutes!
×