Adjust clutch hydraulic - 1990 Toyota Camry

Hi Lain,

The Hydraulic clutch on your Grand Vitara is non adjustable.
The hydraulic cylinder will self adjust/position itself as the clutch wears.
If your clutch pedal friction point is high or clutch is slipping you will require a new clutch kit and flywheel machine.

Cheers.

If it is adjustable it will have a threaded push rod at the slave cyl ,bleed the hydraulic system first adult the clutch then bleed again .

Its fairly easy to determine if your clutch is hydraulic or cable. Check in the engine compartment against the firewall on the drivers side, and see if there are one or two hydraulic reservoirs side by side. If there are two, the far left one is for the clutch, and you have a hydraulic clutch.
If you have a cable clutch, the cable should be clearly seen by the side of the brake hydraulic reservoir, a rather thick cable running from the firewall to the bell housing area.
There are two possibilities for adjusting - the adjusting nuts are either at the point where the outer part of the cable enters the firewall to connect to the clutch pedal, or where the inner cable connects to the release bearing fork.
To adjust, release the outer nut (there should be two, one is a locknut) and take up the slack by screwing the other nut inward.
Make sure you don't overtighten the cable, this could lead to your clutch slipping and you will need to replace the clutch plate sooner.
A hydraulic clutch is usually not adjustable, so if you have a problem there, take it to a service station.
Have fun.

as you hav'nt mentioned vehicle etc as a general rule hydraulic clutch's self adjust , so yours would appear to need a new clutch

Hello siscabella, you may not have a clutch cable, most newer cars use a hydraulic clutch.
You should be able to call any parts store to confirm that your clutch is hydraulic.
Many prefer the old machanical clutch because you could adjust the cable to get more clutch, but, the hydraulic clutches are not designed so you can adjust it. If you have a weak clutch, you will most likely need a new clutch in the near future.
I hope that I've been helpful.

With a hydraulic clutch there is no adjustment as the slave cylinder does that automatically by using the fluid.

u do not have a clutch cable, the system uses a hydraulic clutch release, it is self adjusting, when the clutch starts to slip or engage high on the pedal the clutch is worn out, average cost to replace this clutch isw around $600 on this SUV

Sorry, there are no adjustments on your vehicle., The clutch is activated via hydraulic pressure. The master and slave cylinders are "self-adjusting". If the clutch is slipping, you are going to need to pull the trans and replace the clutch assembly. Changing the hydraulics will not help a slipping clutch at all.

Thanks for choosing FixYa for advice!

You car does not have an "adjustable" clutch. The Corolla uses a hydraulic clutch. The action of the hydraulics eliminates the need for adjustements. If the clutch is slipping, you may need to replace the clutch.

Only clutch adjustment is at the pedal as they are hydraulic. Clutch may be worn, cheers