SOURCE: Change a water pump
1. Remove negative battery cable
2. Open radiator valve - drain cooling system
3. Remove cooling fan and shroud
4. Remove belt
5. Remove water pump pulley from hub
6. Remove hoses from water pump
7. Loosen heater hose coolant return tube mounting bolt and nut.
8. Remove the tube. Lose the O-Ring.
9. Remove water pump mounting bolts
10. Loosen the clamp on the bypass hose.
11. Remove the hose as you pull the pump away from the engine.
Hope this helps
Mike
SOURCE: 1998 jeep grand cherokee
Please use this link :
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800a98dd
Good luck..
SOURCE: coolant level sensor bad warning comes on console
Coolant sensor wiring would be the next place to look. Make sure connector is good, and look for broken wires.
SOURCE: where to replace coolant temp sensor for 1998 grand jeep cherokee
Check this image...
...in the Section ZJ-Secc-8D-Ignition-Systems (page 5, fig. 10 and 11).
Good luck.
SOURCE: 1996 Jeep Cherokee coolant sensor bad
This trouble is common in this models, I have one '93 ZJ and my signal Sensor Coolant Level also is ON for long time; first, try to clean the plug and reset the ECU. If the signal show again, maybe you need replace this sensor.
For more details about location and diagnotics, check this documents:
ZJ-Secc-8D-Ignition-Systems
- Page 5 Location (Coolant Temperature Sensor)
- Page 11 Diagnostics/Service Procedures
- Page 24 Removal Components
ZJ-Secc-7-Cooling-System
- Page 23 Coolant Reserve Tank (Coolant Sensor Level)
I hope help you with this (remember rated this help) Good luck.
179 views
Usually answered in minutes!
×