Need instructions for replacing the starter - SC 300 Lexus Cars & Trucks

It will take many pages of instruction for someone to tell you this.
I can but sketch it.
For detailed instruction, you will need to go to a public library or a car parts store and get a repair manual, they are year and model specific.
Disconnect the battery.
Find the starter and unhook the wires.
Unbolt the starter from the motor.
Replace the starter and bolts.
Replace the wires.
Hook the battery back up again.
God bless your efforts.

Anon. Do you have to crank the engine over a lot to get the engine started, do you need a tune up? If it a factory stock engine and you are sure it is correct starter and installed properly (with shims if required for meshing gap), makes me think there may be a damaged ring gear on the flywheel/flexplate. Also make sure starter is quality part.
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Have to Replace the Starter About Every 6 Months or So What Is
How to Properly Shim Starter
ebay replacement starters avoid them

1 disconnect battery 2 remove any wires connected to the starter 3 remove mounting bolts 4 catch the starter and manouver it through your suspincion 5 you may need to reverse 2 and 3 depending on how hard the wires are to get to 6 now revers these steps with new starter

You remove the starter

Then replace the solenoid and
reinstall the starter

Not a real difficult job,if you need
instructions I would suggest you
jack up the car,support it,look over the
task first

If you have very little in the way of tools,
no metric tools, you will want an experienced
car guy there to show you how

Pop the hood and unbolt the


Read more: How to Replace a Starter on a 1997 Buick LeSabre ' eHow.com http://www.ehow.com/how_5988824_replace-starter-1997-buick-lesabre.html#ixzz15au6gzk4

starter is on bottom, passenger side of engine; however please see my tip at http://www.fixya.com/cars/r5821173-doesnt_car_start_gasoline_engines before replacing. These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.

if it doesn't crank, maybe a dead spot on starter commutator. Next time it happens, try smacking the starter with a hammer. If this works, replace the starter.

Please see my tip at http://www.fixya.com/cars/r6222268-engine_doesnt_crank_turn_over . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.

Disconnect the battery.
Disconnect the wires from the starter.
Unbolt & remove the starter.
Bolt the new starter into place.
Connect the wires to the starter.
Connect the battery cables.

Disconnect negative battery cable. Remove mounting bolts from starter. Pull it out of the hole, and down to where you can access the wires. Pay close attention to how they are put on. You want everything pointing the same direction when you're done. Remove the wires, and install new one in reverse of above.

chb725: If you go to mybunkey solutions and see the heading " "Starter, battery and alternator ok", you will find that I have given instructions for the removal and installation of a starter for a 1995 Nissan Maxima, in great detail.
The instructions include the tools needed, proceedures in a sequence more detailed (which you will not find in any book) and precautions to be taken during the removal and installation of the starter.
I hope this will provide the answer you are looking for. If not, I will await a more detailed request from you.