I HAVE A 2004 VW PASSAT, GLX 4-MOTION WAGON. I HAVE THE OWNER MANUAL BUT THE SECTION WITH THE AUDIO RESET/UNLOCK INFO IS MISSING. MY MECHANIC JUST FIXED A "CHECK ENGINE" PROBLEM AND NOW THE RADIO READS "CHECK" WHEN I TRY TO TURN IT ON. THE VIN #WVWYH63B94E129925. CAN YOU HELP? (I DON'T WANT TO GO TO DEALER; TOO FAR AWAY) THX
SOURCE: radio unlock code
For this code you most likely would have to get it from VW. Unless you get lucky and fine it on the internet. There is a good site to fine that can off stuff just look up the web site scribd.
Hope that this helps.
Cheers
SOURCE: re sitting the radio in my VW golf
The number buttons on the stereo change the code, so push the 1 button 3 times for 3, 2 button 1 time for 1, and so on. If your code was 2255, you'd hit the 1 button 2 times, the 2 button 2 times, the 3 button 5 times, and the 4 button 5 times. When the code is displayed on the screen, you press Mode and Scan at the same time AND HOLD THEM until the radio unlocks. It'll let you know if it's the right number.
SOURCE: Check engine light on. Trouble code P0599.
this code is for the theremostat heater control sensor that is under the intake. very labor intensive and should be handle by a quilified tech. the reason the code will not clear is because it is a hard fault and it is seeing it constantly or you do not have the proper scan tool with the correct software. it needs to be vag software and you can get one of these off ebay for under 50 dollars.
you can check the respected fuse for ecm circuit -j220 if that is okay it will need to be tested further.
let me know if you have any more question. good luck
SOURCE: I have a 2001 vw passat GLX 4 motion. The mirror
double sided tape and bluetac worked for me!!
SOURCE: I have a 99 vw
IMPORTANT NOTE: You must have the security anti-theft code for your VW radio from the car manufacturer, or from a VW dealer!
The sequence of programming for VW radio is:
1. Push simultaneous "SCAN" and "RDS" keys until on the screen will appear "1000" displayed.
2. Release keys. No more push on "SCAN" and "RDS" keys because otherwise number "1000" will be considered as first safe code attempt.
3. By the #1 key you will set up the first safe code digit.
4. By the #2 key you will set up the second safe code digit.
5. By the #3 key you will set up the third safe code digit.
6. By the #4 key you will set up the four-th safe code digit.
7. Then push again simultaneous "SCAN" and "RDS" keys for confirm this safe code. On the screen will be displayed "SAFE" notice. Release keys! For few seconds a radio frequence will be displayed. The radio is now ready for use!
377 views
Usually answered in minutes!
×