SOURCE: 2001 sebring will turn over but will not start
Most Chrysler cars do have an anti-theft system that can cut out the engine.
I would call the service department, with your VIN handy, and see if yours was equipped with one, and what you need to reset it.
If that isn't the problem, your EGR valve might be bad, or the sensor for it. I've seen a lot of cars where if either the valve itself, or the sensor are malfunctioning, the car won't run properly.
I would also check your MAF and IAC, as those can cause the car to not run.
If you can, get an OBDII code scanner, and pull the codes from your car, they might give you a more specific place to look. (Most parts stores will let you take one home, you put a deposit down, and get it back when you bringthe scanner back to them)
SOURCE: 1996 Chrysler Sebring Conv.- Power Drain or Damaged Crank Sensor?
try checking the secondary ground wire that comes off the battery see if its loose or corroded might help
SOURCE: 99 sebring won't crank
I would lean towards looking over the fuses again, that sounds like it would be caused more from a fuse than anything.Did you check both fuse locations?
SOURCE: i have a 2001 sebring
when installing a new chysler pcm you must have it programed by the dealer to learn your venicle by the vin number......butsound like you had the no start before the pcm did you check for fuel presure.......did you ckeck injector pulse....and did you ckeck for spark at coils thats where you should have started......
181 views
Usually answered in minutes!
×