2006 Jeep Liberty parking lights on driver's side won't work

You will find it bolted in to the hub assembly, behind the rotor, I believe you will need a 10mm wrench to remove it, pull straight up and out

THAT RIGHT IF BRAKE SWITCH BAD NO BRAKE LIGHT WILL WORK.SPRAY ELECTRICAL CLEANER IN BULB SOCKET BULB SOCKET COULD HAVE OXIDATION AND CORROSSION CAUSING POOR CONTACT.

CHECK FRONT SIDE MARKER LIGHT COVER SHOULD HAVE SCREWS TO REMOVE LIGHT COVER SCREWS THEN YOU CAN REPLACE BULB.

you may have ablown fuse or a bad ground

2005 jeep liberty,the key will not unlock the driver side door and the power lock will not unlock the driver sider door.

1) You will need to open the rear swing door.

2) On the inside jam there are two torx headed screws (T-15's if I remember correctly).

3) Unscrew the two torx screws.

4) The light is now held by two mounting tabs (small spherical headed plastic sets that go through a rubber grommet).

5) You will need to pry the light casing off (easy pressure with a good size flat head screw driver will do the trick).

6) The light bulbs are twist mount settings inside the light casing.

7) Twist out the mount setting, change the bulbs, and reset the light mountings.

8) To put the light casing push the light casing back on and put in the screws. Everything else will work in reverse when it comes to assembling the whole unit.

2006 Jeep Liberty Replacement Light Bulb Sizes
Low Beam Headlamp Bulb Size: 9007
High Beam Headlamp Bulb Size: 9007
Parking Light Bulb Size: 2825 or 3157
Front Turn Signal Light Bulb Size: 3157
Rear Turn Signal Light Bulb Size: 3757ALL
Tail Light Bulb Size: 3157
Stop Light Bulb Size: 3157
High Mount Stop Light Bulb Size: 921
Fog/Driving Light Bulb Size: 9145 or H3-55W
License Plate Light Bulb Size: 168
Back Up Light Bulb Size: 3157
Front Side Marker Light Bulb Size: 168
Ash Tray Light Bulb Size: 161
Map Light Bulb Size: 578
Dome Light Bulb Size: 578
Step/Courtesy Light Bulb Size: 906
Trunk/Cargo Area Light Bulb Size: 578

Thank you for using fixya, and good luck

it is the 2nd cylinder back in the right hand bank pf cylinders as you stand in the front of the truck, that is the drivers side..

Check fuse.

Signals are now controlled by a module on the right side of the steering column under the dash. Before doing anything yourself, bring it to the attention of the guys that did the rear...This problem can happen at any time but they may have disconnected a harness or ground while working, so give them a chance first to correct it.

Standing in front of your jeep and facing the engine. The number 1 cylinder is the one closest to you on your right (the drivers side of your jeep). The middle cylinder on the drivers side is the number 3 cylinder.

Driver Side Front to back is 1-3-5
Passenger side Front to Back is 2-4-6