Brake job on 1994 isuzu trooper

Question edited for clarity. Wrong type of break / brake.
Question moved to model category.

Check the brake switch with a meter first. Then check headlight relays and fuses.

https://www.planetisuzoo.com/threads/no-brake-lights-with-headlights-on-1991-trooper.151493/

https://www.google.com/search?q=1999+Isuzu+Trooper+brake+lights+not+working

..

the Isuzu trooper 1999 model doesn't have a brake relay, it only have a brake switch locate the the back of your brake pedals

this video is for a 2000 model but will be very similar
https://www.youtube.com/watch?v=8hk3cZY2UYg
Front brake job on 2000 Isuzu Trooper

Most likely, you just need to replace your brakes. The longer you wait, the more expensive the repairs will be.

Yes, they should be. The Rodeo and Trooper LS (3.2L) definitely have the same rear calipers.
All you need to do is punch in both models on napa or autozone.com, and ensure they list the same parts.

You can remove the dash urself.Its quite simple.4 screws.Then you can check the wire plugs at the back.And you can change the bulbs by twisting the plasic ends,
for your brakes change the pads..

the brake caliper is frozen, this is usually caused by an extended trip to heat up brakes, followed by submerging caliper in or washing with lots of water

or hitting puddles at high speed while hot

This is a simple job that is why it is not very detailed in your book. Nothing special. Do one side at a time so you have a reference to how to reassemble it. Remove your tire , brake calipers be sure not to stress the rubber brake lines or open the brake lines to air. Remove both upper and lower ball joints. When taking out the ball joints remove the cotter pin and bolt and beat the **** out of the joint for it to release. Then the C/V axles will come right out with a bit out encouragement. You will need a few tools wrenches pry bar hammer. I would buy a Chilton's or a Haynes repair manual for torque specs for reassembly. Good luck and take your time. And unless the axles are making noise you can just replace the rubber boots. Which is alot cheaper.

you can do it. time consuming as with any repair at home.as long as you got repair manual & proper tools.if ur not sure go to autozone.com put in ur info .then you can view step by step instructions with pix under repair info.good luck!

Hi ,you should check the rear brakes of your vehicle ,it is posible that they are not returning back when the brake is applied,the brake cilinders may be staying open , c1