Are there any instructions on removing the actual tank? Because I am trying to get to the motor but I can't get it loose, and I believe I have all of the bolts off, but there is a rubber plug-ish thing that seems to be holding it to the fender from behind the tank near that junction.
Helllo there
What model and years is your Porsche?
SOURCE: how to remove tail light housing from fender
The previous owner had left a socket on the tap under the fender!! There are two taps on the housing that hold the tail light to the fender. Taking these two off allows the taillight to be removed.
SOURCE: I need to replace the blower motor -need help on the HOW TO?
Hi: First I would check to see if power getting to blower motor plug... in getting power then cut out plastic and proceed to take out blower motor... should be about 6 screws holding it in...
SOURCE: 2001 S Type Jaguar Sport windscreen washers don't work
make sure hoses are attached to jets somtimes blow off if there has been icy weather
SOURCE: Rattles behind dashboard on Ford Fusion 2 '05 plate.
THIS SOUNDS SIMPLE, BUT MAKE SURE YOUR
SUN VISORS ARE SNAPPED IN PLACE. THIS
WAS THE CASE ON MY MILAN AND YOU WILL
SWEAR IT'S COMING FROM THE DASH.
SERVICE ADJUSTMENT PROCEDURES
1.
Check the washer fluid contact point.
2.
Adjust the washer fluid contact point by using a metal wire to move the washer nozzle ball.
3.
If the amount of washer fluid is too small, check for clogged, bent or crushed washer piping. Check the chipped points too, because the tube might be crushed.
64 views
Usually answered in minutes!
×