Remove the door trim and the trim behind the back of the mirror. Follow the wire and unplug the undo the 3 nuts and take it all out through the hole in the door were the wire came in then reverse to refit
SOURCE: replacing passenger side mirror
no the door pannel does not need to come off but there is a triangle shaped plastic trim pannel above the door pannel that needs to be removed to access the mounting bolts.
SOURCE: remove passenger side mirror
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
SOURCE: Replace 2007 Toyota Rav4 super sport passenger side door mirror
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
SOURCE: How to replace passenger side mirror on 2007 Camry
To remove mirror pry off inside triangle panel(black) which exposes 3 nuts which are removed with socket wrench. Detach wire harness and pull out mirror assembly. To replace insert new mirror screws thru assigned holes and reconnect wire harness and tighten nuts to snug. Push inside triangle panel back into place and you're done! It's that easy.
SOURCE: The driver's side mirror does not work on my Lexus
try moving in the up/down postions with you hand...could have debris jamming the gears inside.
could be a loose connector in the power bezel. pop it off and check the connectors.
623 views
Usually answered in minutes!
×