It is on the throttle shaft,2 little bolts . Should have turned on the check engine light if it's bad ,would stumble and possibly die on acceleration,best to get it scanned at a parts house to see if it has a TPS code or not
SOURCE: 85 Toyota Celica GT Headlights problem
There is a knob beside the headlights under the hood, fairly good sized, looks like rubber and you can manually turn down your headlights. That happened to my 86 Supra last year and the sync was just off and once I turned them down they started working perfectly. Hope this helps
SOURCE: No spark, 1988 Toyota Camry 3SFE 4cyl, 5 speed.
there is no crank sensor on this vehicles 2.0L. If you have power to the coil, new coil, cap and rotor try this if not done yet>>>Unplug coil power first....Try pulling off the distributor cap, and make sure the rotor is spinning with the cam...If this fails to spin, inspect the entire distributor assembly. If it passes, Inspect all the power circuit and wiring to the dist assembly, if ok possible ecu. i recommend having a mechanic check it out!! Hopefully this helps...please rate...thanks
SOURCE: how do you change a rear main oil seal in a 2000 toyota celica gt
First of all, be certain that the leak is in fact from that seal. many leaks travel to that area.
To change the seal is fairly involved, you need to pull the trans and flywheel. There are some specialzed tools involved. Do you have manual or automatic? Manual requires clutch plate alignment on re assembly, by the way , if manual, be sure to change the release bearing and pilot bearing at minimum. Commonly it would make sense to change the clutch during this process....you're already all the way in there..
SOURCE: I have a 2000 Toyota Celica GT/S. How do you
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
support.
You will have vertical adjustment screws for each independent beam
(separate highs and separate lows, but will be same screw if highs and
lows are the same bulb). You may also have additional horizontal
adjustment screws as well
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
SOURCE: nee the timing position or diagram for timing for toyota celica
phone toyota and they will tell you :) p.s timing belt
478 views
Usually answered in minutes!
×