How do you get the headrests out of the front seats in a 1983 Mustang Convertible?
SOURCE: cannot remove front seat headrest, 2001 Saab 9-3
There Is A Button At The Bottom Of One Of The Silver Posts Hold It The Whole Time You Are Lifting The Headrest Out. The Little Button Is Almost Always Grey Plastic.
SOURCE: How can I remove front row seat headrest?
Most volvo headrest can be removed by releasing the catches which are on the back of the headrest on some models and on the front on others I believe on 960 they are on the back. To release the seat on a 960 look where the shafts should be then follow it down on the back where the seat back top stops then goes in press around that area you should be able to find the catch there pull up on the headrest while releasing the catch you have to do this on both sides. The headrest should come off this also works on 740 and 760 series the volvo 780 is a different story the only way to get the headrest off on that is to disassemble the seat
SOURCE: How can I remove the front seat headrests on 2005 Tahoe?
pull them all the way up and some models have a button inside or on the side to push in while removing in an upward thrust others may simply just with a bit of thrust will come right out very easily
SOURCE: I'm trying to remove the headrest on my 2003
On the part that you squeeze to raise the head rest is a little hole on the inside between the 2 bars. You need to push a paper clip or something like that in the hole to release the stop and keep pushing as you lift. Once that is done then you can pull the rest out.
Good luck
SOURCE: cannot remove back seat headrests for 98 328i
Im doing the same thing.. Push the headrest full forward, then lift hard to get past last indent in pole.. This worked for the front as well.. i also could not find a hole to push
223 views
Usually answered in minutes!
Does the tool slip down the front of the support in the channel? Is it just a piece of flat stock or does it have a key type end? I triesd a piece of shim stock down the back but that yeilded no rusults. Thanks for your help
there is a special tool, trim shops would have it.
×