I have service stability light on & ABS light & the traction control light is on i went auto zone to get the code read but it gave me no code i drive it it feels like the breaks are coming on by its self how do i fix this problem i don't want to go to the deal with there prices i thought it might be the yaw rate sensors

Just like with every other type of warning light, if it's on, there's a trouble code stored. Get the codes read and post the code. Then we can help.

problem usually narrows down to abs system problem or hub failing causing problem with abs --have vehicle scanned for the trouble code it will assist you as where to start in repairing problem most auto stores offer this service for free --in the mean time pull the abs fuse so brakes can revert to a normal non abs system till repairs can be made

VWVortex.com - Traction control light flashing, losing power?

forums.vwvortex.com > ... > VW Model-Specific Forums > Golf IV R32

May 20, 2011 - 25 posts - ‎14 authors
So last night I was driving home, went around a pretty sharp turn and my traction control light started flashing for about 5 seconds, then went ... Traction control and ABS light issues
15 posts
Feb 22, 2010
E-Brake warning light stays on -- help
22 posts
Sep 27, 2004
More results from forums.vwvortex.com

Abs and Esp Lights on!? - TDIClub Forums

https://forums.tdiclub.com/showthread.php?t=333091

Oct 18, 2011 - VW MKV-A5 Golf/Jettas. ... Suddenly i noticed that the ABS and the ESP light on the dashboard was on. ... Fuel Economy: 47+ Avg (Passat DSG) 50 Avg (SE Manual) Warm Weather. ... I might suggest that your ABS and traction controlpick up their information ... A bent ring or bad sensor will set both errors. On-and off grinding on hard left and traction control light ...
Nov 3, 2015
ABS brakes activating when slowing down - wheel speed indications ...
Jan 20, 2012
More results from forums.tdiclub.com

Electronic Stability Control - Auto Diagnosis Repair Help

Changing brake pads and rotors will not solve this problem. Go to Auto Zone and have them read your computer for ABS codes and then you can zero in on the problem.

take out the part you have fitted and have the OBD codes cleared ,then refit the part and see if the same happens

All are tied into the ABS system, traction as well as stabilization, This needs to be looked at by someone who can hook up a diagnostic tester to read the fault codes stored in the ABS system then perform the correct diagnostic procedures to isolate the problem

the warning light is advising that there is a problem with ur all wheel drive usually a sensor or an abs sensor /chevys nox rear also has a filter and a certain lubricant which may need service have vehicle scanned some auto stores such as auto zone /advanced auto do the scan for free the trouble code is ur best start point

check abs wires and connections for loose / unclipped connections or damaged if good sensor or connection may be going bad have vehicle scanned for trouble code sum auto stores such as auto zone/ advanced auto do it for free if bad sensor or unit code will advise which and where problem is abs problem usually will affect traction control

Hi there.Whats happening here is an abs sensor in the wheel has failed.In doing so it will turn off your traction control because your abs breaks and traction control work together .If maybe you have an auto zone near by they can scan your break system to find what abs sensor is causing the problem.I hope this clarified some for ya..Auto zone will scan the car for free so that won't cost you anything.You can drive the car you just wont have abs and you should get it fixed.Again I hoped I helped you and if you need further assistance I'll be here to help you..Have a great day..

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589