What are the probable causes of DTCs P0171, P0174, and P0455?

P0300 - random misfire , P0171 & P0174 lean code's . All of this means you could have a bad vacuum leak ,low fuel pressure ,clogged fuel filter , Mass air flow sensor problem .
Ford 150 P0171 P0174 Trouble Codes vacuum leak water test
Low fuel pressure causing P0171 and P0174 trouble code

code p 0171 refers to system too lean bank 1===causes --intake /exhaust leak---AIR system---MAF/VAF sensor---fuel pressure/pump---injector/s---HO2S
In this case I would suspect the heated oxygen sensor (HO2S)
then check fro a cracked flex section in the exhaust before the cat converter
code p 0174 refers to system too lean bank 2---causes intake /exhaust leak--fuel pressure/pump---injector/s---AIR system---hose connection/s

Please go to this site on pc, It will tell the meaning of the codes and detail info. God-Bless! ( repairpal.com/obd-II-code-po171-and-po174.) Clink on first link, when page comes up.

System too lean can be low fuel pressure, fuel filter dirty, fuel pump weak or dirty pump sock/filter, dirty/restricted fuel injectors, MAF contaminated, exhaust leaks near O2 sensor, EGR gasket or diaphragm leaking . The P0500 speed sensor code could be a wiring/connector issue or the sensor itself. Check and clean the connections first.

Hi Guy,here's a link to your codes. P0171 and P0174 OBD II Trouble Codes

Hi there:
DTC P0171 - System Too Lean (Bank 1)
Basically this means that an oxygen sensor in bank 1 detected a lean condition (too much oxygen in the exhaust). On V6/V8/V10 engines, Bank 1 is the side of the engine that has cylinder #1.

Note: This DTC is very similar to P0174, and in fact your vehicle may show both codes at the same time.

You will more than likely not notice any drivability problems, although there may be symptoms such as a lack of power, detonation (spark knock), and/or a hesitation/surge on acceleration.

A code P0171 may mean that one or more of the following has happened:
The MAF (Mass Air Flow) Sensor is dirty or faulty. Note: The use of "oiled" air filters may cause the MAF to become dirty if the filter is over-oiled. There is also an issue with some vehicles where the MAF sensors leak the silicone potting material used to protect the circuitry.
There could be a vacuum leak downstream of the MAF sensor.

Possible solutions include:
In the vast majority of cases, simply cleaning the MAF sensor does the trick. Consult your service manual for it's location if you need help. I find it's best to take it off and spray it with electronics cleaner or brake cleaner. Make sure you are careful not to damage the MAF sensor, and make sure it's dry before reinstalling
Inspect all vacuum and PCV hoses, replace if necessary
Check for a dirty fuel filter and proper fuel pressure


On rare occasions, a check engine light may be experienced with DTC P0171, P0441, P0455, and/or P2420. These DTCs may be a result of an internal PCM driver issue that may keep the EVAP purge solenoid control circuit grounded at times instead of supplying a pulse width signal on the circuit. ask your dealer and check this TSB:
#PIP3621: DTCs P0171, P0441, and/or P2420 - Inspect Production Part Number on PCM - keywords CEL check ECM EVAP lamp lean light repeat trim updated - (Nov 9, 2005)
Subject: DTCs P0171, P0441, P0455 and/or P2420 - Inspect Production Part Number on PCM

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

HI the DTCs you listed P0171 P0174 are lean fuel trim codes. I see alot of faulty O2 sensor cause these to set along with leaking intake gaskets and fuel pumps. Without being able to see actual data from the trucks system its impossible to pin point the cause I can only give what issues we see the most of

Fuel Sys, Driveability, Filters (Air & Fuel)
2006 CHEVROLET COBALT

02/01/2006 ELIMINATION OF FUEL FILLER TUBE FLAPPER DOOR 03/01/2006 ERRATIC FUEL GAUGE READINGS 06/01/2006 USAGE OF E85 FUELS IN GM VEHICLES - REVISED 06/01/2006 L61 ENGINE MALFUNCTION INDICATOR LAMP (MIL)/SERVICE ENGINE SOON (SES) LAMP ILLUMINATED WITH DTC P0171 "FUEL TRIM SYSTEM LEAN" SET 07/01/2006 TOP TIER DETERGENT GASOLINE - DEPOSITS, FUEL ECONOMY, NO START, POWER, PERFORMANCE, STALL CONCERNS - REVISED 07/01/2006 USE OF E85 FUELS IN VEHICLES NOT CERTIFIED BY GM AS BEING FLEX FUEL COMPATIBLE / AFTERMARKET CONVERSIONS OF VEHICLES TO OPERATE ON E85 FUELS 09/01/2006 397.pdf&btitle=2006 CHEVROLET COBALT&yr=2006">GM FUEL SYSTEM TREATMENT PLUS, FUEL SENDING UNIT CORROSION AND FUEL SYSTEM DEPOSITS - REVISED 11/01/2006 940.pdf&btitle=2006 CHEVROLET COBALT&yr=2006">ERRATIC FUEL GAUGE READINGS - REVISED 03/01/2006 USAGE OF E85 FUELS IN GM VEHICLES - REVISED 12/01/2006 TOP TIER DETERGENT GASOLINE - DEPOSITS, FUEL ECONOMY, NO START, POWER, PERFORMANCE, STALL CONCERNS - REVISED 01/01/2007 EMISSION RECALL - ENGINE FUEL INJECTORS - REPLACE 01/01/2007 LSJ, L61, LK5, L52, LL8 ENGINE - REDUCED ENGINE POWER, MIL/SES LIGHT, DTC P1516, P2135, P2138 02/01/2007 MULTIPLE DRIVEABILITY SYMPTOMS DUE TO CLOGGED FUEL INJECTORS, MIL/SES DTCS P0171, P0172, P0174, P0300, P1174, P1175 - REVISED 03/01/2007 MULTIPLE DRIVEABILITY SYMPTOMS DUE TO CLOGGED FUEL INJECTORS, MIL/SES DTCS P0171, P0172, P0174, P0300, P1174, P1175 - REVISED 05/01/2007 MULTIPLE DRIVEABILITY SYMPTOMS DUE TO CLOGGED FUEL INJECTORS, MIL/SES DTCS P0171, P0172, P0174, P0300, P1174, P1175 - REVISED 06/01/2007 <A href="http://arrc.epnet.com/autoasp/data.asp?sid=122357497&uid=s9193090.remote.autorefctr&type=pdf&ff=082000

po171 is system too lean,bank 1,po174,is system too lean,bank 2,It sounds like a fuel pressure problem.