- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The way to start is to ck your battery for 12V & clean bat terminals. Ck the ignition fuse &locate & ck the starter relay for power & ground. Jump the relay between the 2 conn (pwr/grd) See if you start.. Key on If OK r/r relay, If it doesn't work, follow the RED wire to the starter & ck for 12V there. Also ck for a good ground conn at the starter (both with good readings & clean conn. If all is well there when someone else is turning the ignition key to start, then the starter is NG If readings at the starter NG, relocate the starter relay. Good luck, Frank M
Hi, sounds like fuel pump. If the pump doesn't deliver enough fuel ,it will stall. Get your mechanic to check it out. If you have knowledge of how an engine and all its components work then go a head with repairs. If you don't know you will get into trouble quick. Good luck
Ok let's start go dollar store buy a cheap test light go to under the fuse box under hood driver side get the end of test light get good ground touch both end of all the fuses the test light should turn on if not u don't have a good ground on the test light touch both top ends of fuse the test light should light if not one fuse is burn ck them all if ok on the driver side next to the foot brake is ant hoe fuse box do the same if all good get flash light look at the harness under seat on the red wire ck for 12 volts the test light should come on if not ck grounds does the passenger side work
remove grill ck horns with jumper wires ck plug for power, if horns work .if horns dont work with jumpers replace . if no power ck fuse if good relay for signal and power if no signal when horn pushed either horn switch in airbag ,or cable reel witch need cked with special srs tools .
ck for power to coil if power ck coil. if no power ck fuse ck relay for power jump at pressure sensor turn on control to a/c ck relay for signal power if no signal ck control panel if good ck ecm .
ck battery cables ,ck battery voltage,if good ck fuses use owner manual index for fuse box locations and fuse numbers,if all are good and still has no power inside or to dash it will have to go to chevy.
×