2006 Honda Accord was serviced but oil life light is flashing at -17

1. Edit Step 15 ¶ When it's time to change the oilin your Civic, the maintenance light (orange wrench) will appear on your dash, as well as a B1 message, showing an oil life of 15% or less. To reset the Oil Life % gauge, press and hold the SEL/RESET button for about 10 seconds until the Oil Life message begins to flash.

2006-2011 Honda Civic Oil Change (1.8L) - iFixit

https://www.ifixit.com/Guide/2006-2011+Honda+Civic+Oil.../6446 iFixit

CEL, check engine light? if this light is on then theres a problem and the computer needs to be scanned for codes, the codes will tell you where the problem is, there are many autopart stores that will scan it for free and give you the codes. if your problem is the service light then heres how to reset it, turn key on and press the select/reset knob repeatedly until the oil life indicator is displayed then stop, next push knob again and hold for 10seconds until display oil life blinks then push agian and hold for about 5 sec the item will disappear and your done oil life will go to 100%. good day.

When was the engine oil last changed? This sounds like it is a service reminder light to inform you that the vehicle is due for a service. If was recently serviced it will just need resetting.

Is the oil life low? If so scroll up the oil life and hold down the RESET knob until it goes out. If the oil life is high, then service is needed.

Honda Accord 1998-09 To reset MAINT REQ’D light, press and hold select/reset button on right side of instrument panel. Turn ignition on and hold until the light goes out.

On the right of your dash is a pair of buttons, one for selecting/changing the odometer and the other for cycling from MPH to KMH and back.
Turn the key on.
Push the select button until your display indicated the remaining oil life percentage. When it is displayed press and HOLD the select button until it begins to flash. Once it starts flashing release the button and press and hold it again. The display will clear and if you release the button and cycle through the display with the select button you will see oil life 100%. Good luck and this should reset the oil life.

yes change it to

take it back to the servicing firm and aks them to finish the job.

Please note:

Honda makes reference to proper vehicle maintenance in their service/user manual. Consult your authorized Honda dealer before doing anything that may void your vehicle warranty.

https://techinfo.honda.com/rjanisis/pubs/om/AC0606/AC0606O00192A.pdf

Owner's Manual page 193-197.

Resetting the Engine Oil Life
Indicator

Your dealer will reset the display
after completing the required
maintenance service. You will see
‘‘OIL LIFE 100 %’’ on the odometer/
trip meter display the next time you
turn the ignition switch to the ON
(II) position.

If maintenance service is done by
someone other than your dealer,
reset the maintenance minder as
follows:

1. Turn the ignition switch to the ON
(II) position.

2. Press the Select/Reset knob until
the engine oil life indicator is
displayed.

3. Press the Select/Reset knob for
more than 10 seconds. The engine
oil life indicator and the
maintenance item code(s) will
blink.

4. Press the Select/Reset knob for
more than 5 seconds. The
maintenance items code(s) will
disappear, and the engine oil life
will reset to ‘‘100.’’

Important Maintenance
Precautions

If you have the required service
done but do not reset the display, or
reset the display without doing the
service, the system will not show the
proper maintenance intervals. This
can lead to seriousmechanical
problems because you will no longer
have an accurate record of when
maintenance is needed.
Your authorized Honda dealer
knows your vehicle best and can
provide competent, efficient service.
However, service at a dealer is not
mandatory to keep your warranties
in effect. Maintenance may be done
by any qualified service facility or
person who is skilled in this type of
automotive service. Make sure to
have the service facility or person
reset the display as previously
described. Keep all receipts as proof
of completion, and have the person
who does the work fill out the
maintenance record. Check your
warranty booklet for more
information.

Information obtained from:

https://techinfo.honda.com/rjanisis/RJAAI001_OMANUAL.ASP?YEAR=2006

If the information provided to you was useful, please rate my response.

Thanks,

OpenSource13

turn ur key on , press ur odometer trip button till u get to ur oil life...once ur oil life is displyed, depress the button and hold it down till your oil life begins to flash, after it starts flashing, release the button then depress it and hold it down till it resets the oil life to 100%....your maint light and oil life should now be reset...

This is what helps the tech inspect your car. B Means to replace oil and oil filter. And inspect certain things on the vehical.

Sub systems
# 1 Means rotate tires and check tire pressure.
#5 Means Replace Coolant

What do you mean 15. Their is no 15 in the Maintenance Minder System.

To reset the Maintenance Minder System (your oil life) Make sure the oil life is displayed
#1 Press and hold the reset button for 10 seconds until the oil life flashes
#2 Press and hold the reset button for a additional 5 seconds.