1998 Mercury Villager Hi speed vibration - 1998 Mercury Villager

SOURCE: where is a knock sensor for 1998 Mercury Villager located?

Here is a image of it's location, I hope it helps.

Harvey N Tawatao

• 3854 Answers
• Posted on Sep 02, 2009

SOURCE: Code reader knock sensor where is it located

According to the Haynes manual it is under the intake manifold, Upper and lower intake manifolds must be removed for access. If you go to Auto Zone, they have the sensor and can give you the step by step instructions to replacing the knock sensor with common tools. Good luck and hope this help.

Greg Bernett

• 2993 Answers
• Posted on Sep 13, 2010

SOURCE: how to replace the speed sensor on a 2000 mercury

Removal & Installation

1. Disconnect the negative battery cable.
   
2. Raise and safely support the front of the vehicle securely on jackstands.
   
3. Disconnect the VSS electrical connector.
   
4. Remove the VSS hold-down bracket bolt and remove the bracket.
   
5. Remove the VSS from the vehicle.
   
6. The installation is the reverse of removal. When installing the VSS hold-down bracket, tighten the bolt to 44–61 inch lbs. (5–7 Nm).