SOURCE: radiator fan relay,2001 chrysler town country
the relay is located in the power distribution box under the hood the relay will be a square black or gray cube just pull out and make sure you rerplace it with the same type relay. refer to your owners manual for any questions regarding the fuses and relays
SOURCE: 2001 Chrysler town and Country tire size
the sticker on the drivers door or door jamb will have that info. plus it is on the side of the tire, starting with P___-__-__
SOURCE: Bank 1 Sensor 1 - Oxygen sensor needs to be
The sensor you indicate would be on the manifold of the head containing cyl.# 1, top sensor (prior to catalytic conv.) 6 cyl. engine. 4 cylinder would be sensor on exhaust manifold. Confirm sensor failure prior to replacing as chrysler harness connectors are known for pin failures at 02 sensor connections. Inspect for burnt pins and cracked/chaffed wires first before changing sensor.
SOURCE: how do i change the oil pressure sensor on a 2000
1st locate your sensor, most of the time, they are up on the engine itself, you will need a oil sending socket and ratchet to do the job, once you locate your sensor, disconnect the wiring connector to it, then remove the sensor, and before you install the new one, take some white teflon tape, that you can buy at a auto part store, and wrap some tape around the threads of the new sensor, [ normally 2-3 rounds is enough tape. ] install the new sensor straight in to the opening, make sure you don't cross thread it, after you get the sensor started, then tighten it up as much as you can with your hand, then finish tightning with ratchet and socket, [ do not over tighten ] then hook wire connection back up, and you are ready to go, start vehichle up and check for any leaks, of the sensor, they shouldn't be any, if you followed these instructions, hope that this has been helpful to you.
SOURCE: chrysler town and country overheats
Welcome to Fixya
If cooling fans are not working then the best place to check first is the fuse box. Check the fox box for any blown fuse related to cooling fans. Replace the fuse if necessary. Test the cooling fans by connecting it to the battery and see if it will spin. If the cooling fans spins then there is a short in the wiring.
Thank you for using Fixya!
If you need further help, reach me via phone at https://www.6ya.com/expert/elixirjose_00375ea24bd8141b
172 views
Usually answered in minutes!
×