SOURCE: fuel filter location
The oil filter is in an aluminum cylinder on the engine. It is not a "spin on" filter, it is now a cartridge-type filter. When you get one, make sure that you use the new o-rings provided in the filter box. The fuel filter is in the tank. Hope this helps, the graciousness of a FixYa rating would be appreciated. Thanks.
SOURCE: I need to replace the rear struts on my 2000
remove the rear seat.
(pull up on the front of the rear seat to remove)
SOURCE: Toyota Avalon 120 amp main fuse removal.
you have to loosen the mounting bolts on the fuse panel and on the bottom side the fuse is held in by 2 8 millimeter bolts.
Testimonial: "Very helpful and exactly right. Saved my neighbor a towing charge to the dealer. His car is back up and running. Thank you!!! "
SOURCE: how do i replace a 120 amp fuse step by step on a
There are several fuse blocks. They are located in the engine
compartment, behind the right side kick panel, under the instrument
panel or behind the left side kick panel.
REPLACEMENT
If
any light or electrical component in the vehicle does not work, its
fuse may be blown. To determine the fuse that is the source of the
problem, look on the lid of the fuse box as it will give the name and
the circuit serviced by each fuse. To inspect a suspected blown fuse,
pull the fuse straight out with the pull-out tool and look at the fuse
carefully. If the thin wire that bridges the fuse terminals is broken,
the fuse is bad and must be replaced. On a good fuse, the wire will be
intact.
Sometimes it is difficult to make an accurate determination. If this is
the case, try replacing the fuse with one that you know is good. If the
fuse blows repeatedly, then this suggests that a short circuit lies
somewhere in the electrical system and you should have the system
checked.
Fig. Once the cover is removed from the fuse box, you can identify each fuse and relay
Fig. All circuit breakers and fuses pull out quick easily
When installing a new fuse, use one with the same amperage rating as
the one being replaced. To install the a new fuse, first turn off all
the electrical components and the ignition switch. Always use the fuse
pull-out tool and install the fuse straight. Twisting of the fuse could
cause the terminals to separate too much which may result in a bad
connection. It may be a good idea to purchase some extra fuses and put
them in the box in case of an emergency.
Fig. Relays can be removed by pulling them from the block
I hope helps with this (remember rated this help) Good luck.
SOURCE: how to remove the rear seat on 96 toyota avalon to
You do need to have a spring compressor. Get the McPherson spring compressor. It is a must. You can rent them at O'reillys auto parts, Kragen, maybe Auto Zone. To get a better understanding on how to change it out, I recommend a chilton 95-97 Camary Manual. Now I can't remember the exact tools you need but the ones I can remember are 22mm socket, 14mm socket, 12mm socket, for the 2 large stubborn bolts I had to impact drill them, and with that 12mm socket don't forget to take the brake line off the strut. When you jack up the car try using its stock jack stand if you dont want to bend the running bars underneath where you jack it up as the car is a unibody jacking it up too high will lift the cars whole side and you only need to jack it enough to take the tire off. The back struts require you to take out your back seat which are also easy to take out.
To remove the rear seat here a link, its on a 2000 but should be generally the same. I learn better with pictures anyway, hope this helps!
http://www.toyotanation.com/forum/showthread.php?p=2924042
397 views
Usually answered in minutes!
×