Fuel pump works, what else could it be. It cranks but wont turn over. Keys were lost so it has no ignition, instead it has 2 toggle switches, one on steering column turns on accessory power and the other is under the dash under the steering column and is a different type of switch and that one cranks the engine. HELP PLEASE!:(
Check the plug wires to see of they spark.
.if not you may not have a good connection on your "toggle" switch on steering column.
Ignitor
SOURCE: 92 honda accord lx
okay everybody...i did it myself....replaced the main relay and the TCU box..but i didnt use another OKI manufactured TCU..i bought the Denshigiken manufactured one....(this was a 2nd manufacturing of the TCU)....when it first arrived today i opened the module up to check the resistors and capacitors...and noticed the completely different configuration and parts inside...this worried me..but i hooked it up anyways...to my amazement all problems vanished ..and everything works now..(cruise control, shift interlock, D4 light, tranny shift, brake light, intermittent no start, everything that was wrong..must have ran through this stupid little resistor) ......i solved his problem for less than $100.00..and less than an hours work....i can get more of these Main relays and TCUs if someone needs or needs help locating and removing/installing new pieces...email me at [email protected] or call me @816-286-8851..ill be glad to help
Main relay ........$10.00..
TCU................. $80.00...
10mm deepwell ...$4.00
SOURCE: 1990 honda accord lx oil leakage problem
I just had my cam shaft seal replaced and then they put a bracket to hold it in place, I have a 99 Honda Accord LX, they didn't start putting the brackets on until around 2000. My cam seal just popped out that's the purpose for the bracket.
SOURCE: how do i remove the rack and pinion on a 1996
there is a pinch bolt that holds it in, make sure you straighten the steering wheel first and lock it down with something so it cant move, then remove the pinch bolt and the pressure and discharge lines from the rack there are return lines within the rack that go side to side, you dont need to remove those. Make sure the replacement rack is even when putting back into steering yolk
SOURCE: honda accord lx 1996 6 transmission dipstick
For the V-6 model, the dipstick is located down low on the transaxle, on the drivers side of the car, if it is low, usually 1 pint of of fluid is needed to raise from low notch to high notch. also if it appears to be dark or burnt, smells burnt, you should replace the tranaxle fluid. Good Luck!
SOURCE: 1994 hoda accord lx brakes
Please refer to the link below.
http://corp.advanceautoparts.com/english/youcan/asp/ccr/ccr20011001bb.asp
205 views
Usually answered in minutes!
No, it ran after the keys were lost and switches installed. (But this took place anywhere from 6mo-1yr prior to me buying it; and I know it sat for quite a long time in the hot az heat also b4 i bought it)
First, did the car run after the keys were lost, or did this problem happen after the switches were installed?
do you know if the injectors are firing?
×