SOURCE: Shift solenoid problem
Here goes.Remove neg batt cable 10 mm, Remove elec connector to solenoid 6mm. Remove trans lines from trans(sometimes you can get away with not doing this) Remove speed sensor connector small screwdriver just to get the tab to release. Use 1inch scoket to remove spped sensor (just needs to be loose) spin out by hand. Remove 3 blolts 8mm holding the solenoid to trans. When puting new one in make sure the area is clean, clean, clean. Use new gasket. Dealer gasket trans solenoid 04659982 & replace o ring on speed sensor part#06501657ab. The bolts on solenoid snug them down but don't over tighten them. The speed sensor is 20lb torque. The right speed sensor part is 06501658ab this one is blue the left is black. Hope this helps.
SOURCE: 1993 Chrysler LeBaron oil pressure switch
j'aimerai entrer en contacte avec pour l'achat de votre vehicule
SOURCE: 1993 chysler lebaron stalled
Hi Seems to be fine now thanks and I have a 1993 chrysler lebaron
SOURCE: 1993 chrysler lebaron steering belt
I'm sorry, I don't think you can get a pic for free, this will cost 25 bucks, or look for it on eBay for cheaper, a Haynes repair guide. http://haynes.com/products/?searchType=vehicleApplicationSearch2&searchEnd=yes&sfID1=&sfID2=&sfID3=&year=1993&make=Chrysler&model=LeBaron&x=6&y=6 copy and paste that into your address bar, or click if it's blue.
SOURCE: 1996 accord lx 4cyl at. Code is transmission input
Stand on passenger side of vehicle with hood up, look down kind of behind the throttle body but still close to the side of the car. It should be sitting on top of the tranny with a connnector with 2 or 3 wires coming out of it. It also has a little straight gear in it that spins with the tranny, make sure and dont drop this out or it wont work.
114 views
Usually answered in minutes!
×