2004 Mazda MPV Logo

Related Topics:

A
Anonymous Posted on Sep 18, 2013

Mazda 3 with P2177 fault code. I installed a bluetooth ODB II sensor and monitored the Fuel Trim Bank1 Sensor 1 & 2. Sensor 1 reports a low single digit value that varies, but Sensor 2 reports a large constant value of 89. Does this indicate a bad O2 sensor or what exactly?

5 Related Answers

emissionwiz

Marvin

  • 85242 Answers
  • Posted on May 20, 2009

SOURCE: Fault code P0133 can't pass inspection.

This code does not always mean the O2 sensor is low, but if u want to replace it here is the info to do that and the part number.

The sensor you want is the one in the exhaust pipe of the engine cylinder bank that has #1 cylinder in it, as you face the engine with the hood open the cylinder bank u want is the rear bank, u will need to jack the car up and get under it to remove the sensor, u may also need a special socket to remove it, the sensor is the one that is before the catalytic converter. part number is:DENSO Part # 2344068
REAR; Before Catalyst

Ad

Anonymous

  • 1056 Answers
  • Posted on Aug 13, 2009

SOURCE: I have a '95 2.5 Millenia. the check engine light

This is all due to a loose connection somewere. If your car had been worked on check all connector that are not plugged in tightly. Some newer cars even have a special lock lever to the connectors, and if not connected properly you would have all kinds of code poping up.

Hrnsly

Romy Kettlewell

  • 154 Answers
  • Posted on Aug 18, 2009

SOURCE: Purchased a bosch o2 Sensor for mazda protege 5

IF THE CONECTOR ON THE END IS THE SAME THEN IT WILL WORK AND THE COLORS DO NOT MATTER. YOU HAVE TO MAKE SURE THAT THE CONECTORS ON THE END ARE THE SAME THE AFTERMARKET SUPPLIER DOES NOT USE THE SAME COLORS AS THE FACTORY. A LOT OF TIMES THAT IS HOW WE KNOW WHEN AN AFTERMARKET PART IS USE.

toneman2121

toneman2121

  • 775 Answers
  • Posted on Apr 01, 2010

SOURCE: Where is Bank 1 Sensor 2 located on a 2004 Mazda

bank 1 is the bank of cylinders closest to the firewall. the sensor will be located along the exhuast from that side after the catylitic converter

Anonymous

  • 1 Answer
  • Posted on Sep 08, 2010

SOURCE: 95 Mazda b2300 ( Engine code p0320) misfire cyl 2

check the feul injector on that cylinder. use a stethoscope to listen to it. injector should make a clicking noise as it operates. if it doesnt click, check the wiring at the terminal. if the wiring is ok then apply a 9 volt battery to the prongs on the injector to check if it is working or not. if the injector for that cylinder is not operating properly then the cylinder will missfire. if the injector and its wiring is good, check the valve clearance with a feeler gauge and adjust if necessary. if the valves are good then test the compression of the cylinder.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2015 Hyundai Sonata LF. Why 'check engine' light on with DTCs P2097 and P2196?

Fuel Air Ratio is incorrect due to failing sensors or broken exhaust. Sensor 1 bank 1 is actually the Fuel/Air Sensors not an O2 sensor. Your is reporting that the ratio is too rich so it is adding less fuel. Whilst this is good for fuel economy, it causes an overheat situation which can damage the piston or burn the valves. I had the same situation in my Lexus, but it was reporting too lean. After the fuel/air sensor was replaced, it reported too lean 100 yards down the road. I cleared that code and all was fine. The engine was burning off carbon die to the rich fuel situation. I recommend this, or a cheap scanner


www.fixd.com


P2097 OBD-II Trouble Code: Post Catalyst Fuel Trim System ...

https://www.yourmechanic.com > Articles
P2097 code definition P2097 is a general OBD-II diagnostic trouble code that indicates a fault with the post catalyst fuel trim system being too rich in bank 1.


P2196 OBD-II Trouble Code: O2 Sensor Signal Stuck Rich ...

https://www.yourmechanic.com > Articles
P2196 trouble code definition O2 Sensor Signal Stuck Rich (Bank 1 Sensor 1) What the P2196 code means This code indicates there is too much fuel in the ...
1helpful
2answers

What is B1218 engine code? have it on a Ford Explorer 2014

B1218 OBD-II Diagnostic Body (B) Trouble Code Description B1218 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses. Reason For B1218 Code The reason of B1218 OBD-II Engine Trouble Code is Ambient Air Temperature Sensor Circuit Low. B1218 DTCs may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.
0helpful
1answer

I am getting the following codes on my 2002 Nissan Altima v6 3.5 liter P1430, P1420, P1805, P1152, P1102, P1011, P1021 & P1335 I'm going crazy here. Please help!

Definition of Diagnostic Trouble Code P1430 Ford: Electric Air Pump Secondary Lincoln: Electric Air Pump Secondary Mazda: Electric Air Pump Secondary Mercury: Electric Air Pump Secondary Toyota: Intake Constrictor CTRL Circuit Open or Short

Definition of Diagnostic Trouble Code P1420 Audi: Second Air Injection Valve Circ Electrical Malfunction BMW: Secondary Air Valve Control Circuit Electrical Buick: Intake Air Low Pressure Switch Circuit Low Voltage Cadillac: Intake Air Low Pressure Switch Circuit Low Voltage Chevrolet: Intake Air Low Pressure Switch Circuit Low Voltage Chrysler: Register Resonant Charging 1 (RRC1) Dodge: Register Resonant Charging 1 (RRC1) Ford: Catalyst Temperature Sensor GMC: Intake Air Low Pressure Switch Circuit Low Voltage Honda: Nox Adsorptive Catalyst System Efficiency Below Threshold Catalytic converter Jeep: Register Resonant Charging 1 (RRC1) Lincoln: Catalyst Temperature Sensor Mazda: Catalyst system efficiency below threshold (bank 1) Mercedes: AIR Pump Switch over Valve Mercury: Catalyst Temperature Sensor Oldsmobile: Intake Air Low Pressure Switch Circuit Low Voltage Pontiac: Intake Air Low Pressure Switch Circuit Low Voltage Saturn: Intake Air Low Pressure Switch Circuit Low Voltage Subaru: EVAP Purge Control Solenoid Circuit High Input Toyota: SCV Control Circuit Malfunction Volkswagen: Second Air Injection Valve Circ Electrical Malfunction

Definition of Diagnostic Trouble Code P1805 Ford: Four wheel drive high indicator circuit failure Lincoln: Four wheel drive high indicator circuit failure Mazda: (4WD) High Indicator Open Circuit Mercury: Four wheel drive high indicator circuit failure Toyota: SB Solenoid Circuit Malfunction

Definition of Diagnostic Trouble Code P1152 Audi: Bank1, Long Term Fuel Trim, Range 2 Leanness Lower Limit Exceeded BMW: Oxygen Sensor Heater Circuit Low Voltage (Bank 2 Sensor 1) Ford: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Rich Jaguar: Lack of H02S-21 switch, sensor indicates rich Land Rover: Oxygen sensor response time bank 2.Short circuit to ground Lincoln: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Rich Mazda: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Rich Mercury: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Rich Subaru: Oxygen sensor range /performance problem (Low) Volkswagen: Bank1, Long Term Fuel Trim, Range 2 Leanness Lower Limit Exceeded Volvo: Oxygen Sensor Front, Bank 2

Definition of Diagnostic Trouble Code P1102 Acura: Mass Airflow (MAF) Sensor Lower Than Expected Comprehensive Audi: Oxygen Sensor Heating Circuit,Bank1-Sensor1 Short to B+ Chrysler: HEV Stop Request Performance Dodge: HEV Stop Request Performance Hyundai: MAP Sensor Circuit Low Input Jeep: HEV Stop Request Performance Kia: Heated Oxygen Sensor Bank 1 Sensor 1 Heater Circuit High Input Land Rover: Throttle to air flow plausibility not active.Last occurrence - minimum signal Mazda: Mass Air Flow Sensor In Range But Lower Than Expected Mitsubishi: Traction Control Ventilation Solenoid Circuit Porsche: Heated Oxygen Sensor 1 Ahead Of TWC Heater Short To B+ Saab: Front Heated Oxygen Sensor Bank 1, Control Module Input, Current in Pre-Heating Circuit Too High Subaru: Pressure Sources Switching Solenoid Valve Circuit Malfunction Volkswagen: Oxygen Sensor Heating Circuit,Bank1-Sensor1 Short to B+ Volvo: Power Stage Group B

Definition of Diagnostic Trouble Code P1011 Saab: Injector Cylinder 1 Shorting To Ground Toyota: OCV for VVTL Open Malfunction (Bank 1)

Definition of Diagnostic Trouble Code P1021 Honda: Valve Pause System Stuck On Comprehensive Mitsubishi: OCV OPN. Bank 1 Saab: Injector Cylinder 2 Shorting To Ground Toyota: OCV for VVTL Open Malfunction (Bank 2)

Definition of Diagnostic Trouble Code P1335 Audi: Engine Torque Monitoring 2 Control Limit Exceeded Buick: CKP Circuit Cadillac: CKP Circuit Chevrolet: CKP Circuit Ford: (EGR) Position Sensor Minimum Stop Performance GMC: CKP Circuit Infiniti: CKP Sensor (Ref) Jaguar: CKPS Circuit Malfunction Land Rover: Exhaust gas recirculation position sensor minimum stop performance. Lexus: Igniter Circuit Malfunction Bank 2 (During Engine Running) Lincoln: (EGR) Position Sensor Minimum Stop Performance Mazda: (EGR) Position Sensor Minimum Stop Performance Mercedes: CKP Sensor Circuit Malfunction, Bank 2 Mercury: (EGR) Position Sensor Minimum Stop Performance Oldsmobile: CKP Circuit Pontiac: CKP Circuit Saturn: CKP Circuit Toyota: No CKP Sensor Signal Engine Running Volkswagen: Engine Torque Monitoring 2 Control Limit Exceeded http://www.obd-codes.com/trouble_codes/nissan
0helpful
1answer

Keeps throwing up trouble codes p1506,p1151,p0302,p0171

Definition of Diagnostic Trouble Code P1506 Audi: Closed Throttle Position Switch Does Not Open/Short to Ground BMW: Idle-Speed Control Valve Opening Solenoid Control Circuit Signal High Ford: Idle Air Control Overspeed Error (see P0507) Jaguar: Idle Air Control System RPM Lower Than Expected - B Bank Kia: IAC Valve Opening Coil Voltage High Lincoln: Idle Air Control Overspeed Error (see P0507) Mazda: Idle Air Control Overspeed Error Mercury: Idle Air Control Overspeed Error (see P0507) Porsche: Throttle Jacking Unit Lower Mechanical Stop, Signal Implausible Volkswagen: Closed Throttle Position Switch Does Not Open/Short to Ground Volvo: IAC Valve Opening Signal
------------------------
Definition of Diagnostic Trouble Code P1151 Audi: Bank1, Long Term Fuel Trim, Range 1 Leanness Lower Limit Exceeded BMW: Oxygen Sensor Heater Circuit Signal Intermittent (Bank 2 Sensor 1) Ford: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Lean Jaguar: Lack of H02S-21 switch, sensor indicates lean Land Rover: Lambda control limit bank 2.Implausible signal/condition Lincoln: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Lean Mazda: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Lean Mercury: Lack Of Heated Oxygen Sensor Bank 2 Sensor 1 Switches - Sensor Indicates Lean Subaru: HO2S-12 Heater Circuit High Input Toyota: Coolant Path Clog Up for Coolant Heat Storage System Volkswagen: Bank1, Long Term Fuel Trim, Range 1 Leanness Lower Limit Exceeded
------------
Definition of Diagnostic Trouble Code P0302 Category: Powertrain Definition: Cylinder 2 Misfire DetectedNote: This definition of P0302 is applied to all manufacturers
--------------------------
Definition of Diagnostic Trouble Code P0171 Category: Powertrain Definition: System Too Lean Bank 1Note: This definition of P0171 is applied to all manufacturers
0helpful
1answer

Mazda3,2005 trouble code p2177 system too lean off idle bank1

Check for correct fuel pressure.
If fuel pressure is low could be bad fuel filter, fuel regulator or pump.
If fuel pressure is correct could be bad MAF sensor, injectors, O2 sensor or vacuum leak on inlet manifold.
0helpful
1answer

Code number for o2 sensor voltage low

Forget to write it down?

Generic or Manufacturer?

There are 41 Generic O2 Codes

PO 131--bank 1 sensor 1
PO 137--bank1 sensor 2
PO 143--bank1 sensor 3
PO 151--bank2 sensor 1
PO 157--bank1 sensor2
PO 163--bank2 sensor 3
2helpful
3answers

Mil on fault code p2188 help please

2188 rich at idle,Ive seen the injector creat this fault by not having the ability to atomize fuel properly are you willy to put a bottle of fuel injector cleaner in the fuel tank. This vehicle is equipt with a air ratio when it fails system goes lean, try this first but dont wait too long rich condition can destroy the catalytic convertor
3helpful
3answers
Not finding what you are looking for?

74 views

Ask a Question

Usually answered in minutes!

Top Mazda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...