A new clutch kit or clutch package has 3 major parts: a new clutch disc (the thin plate with the abrasive surface), a new or reconditioned clutch pressure plate, and a new clutch release bearing (aka, throw-out bearing). Approximately $200 for the package.
Some people have been known to change only the clutch disc (for about $30), and use their old pressure plate and throw-out bearing. Not recommended-same people have been known to have to go back sooner than later to then replace the pressure plate and release bearing. Do it all once, then you won't have to go back and re-do it.
Have you checked the hydraulic clutch operation? Before condemning the clutch disc for failure, make sure the hydraulic clutch cylinder causes the clutch fork or lever to have sufficient travel to engage the clutch when the pedal is depressed. Also check the clutch fluid reservoir for being full.
SOURCE: P0016 CODE KIA SPECTRA 2006
the p0030 is the heater circuit in the o2s bfore the cat. as long as there has been no one cutting through the fire wall(which i have seen) and into harness trying to install a stereo then you should be able to replace the o2 sensor which should still be under warranty. the p0016 has to do with the crank/cam sensor which could be going bad. how does it run? if it runs good or wont start, replace the sensor. happy holidays
SOURCE: won't go into gear to drive. may be transmission?
If the clutch has never been changed most likely it is that. The way you can check it is by removing the transmission and looking at the clutch disc. It could be transmission syncros but I am willing to bet you just need a new clutch.
SOURCE: 2000 kia sportage mass air flow sensor
The mass air flow meter is fitted to the air intake pipe Its quite a simple task to change it on your own.Has for the catalytic converter all you will have to do is give the car a realy hard reving when going through the gears and drive it hard for a few miles.That will clear your cat for you.Dont listen to the shop they are out to rip you off.Good luck.Any problems you can contact me via [email protected].
SOURCE: How do you replace a Drivers side headlight bulb 2006 kia spectra
Helps to remove the battery, but small ahbds can do it.
Directly behind the lens is a big round cap ... twist it off. The bulb is held in place with a spring that locks in to a notch in the holder. When handling the new bulb, don't touch the glass. The oil from your skin will cause it to shatter when turned on.
356 views
Usually answered in minutes!
×