my 88 mazda b2200 will die unless you turn the idle screw almost all the way up, and when im driving at higher speeds the truck runs fine. sometimes it will just completely shut down on highway. the ignition switch also in was told needs replaced for other reasons, and i was wondering if this could be connected thank you
my 88 mazda b2200 will die unless you turn the idle screw almost all the way up, and when im driving at higher speeds the truck runs fine. sometimes it will just completely shut down on highway. the ignition switch also in was told needs replaced for other reasons, and i was wondering if this could be connected thank you
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
many things will cause no spark bad distributor cap or rotor.bad plug wires.ignition timing to far advanced cause by loose distributor.could have faulty ignition coil or module.check ignition fuse.probably could be faulty PCM i would have it checked out.could have bad crankshaft sensor.
need to adjust idle speed by turning air adjusting screw on throttle body idle should be 750 - 790 RPM. make sure spark plugs and wires okay. make sure distributor cap and rotor good.replace fuel filter do a little tune because if engine not fine tuned one bad cylinder will cause engine not to idle if you have fuel injection system clean fuel injectors by filling gas tank full add a can of seafoam to fuel tank see what happens.
Your alternator is not yet doing anything. Minimum voltage, even with all accessories on, should be around 13.5 volts. Check all fuses, connections, grounds, and wiring. Have the alternator tested if you find nothing amiss.
i have a 1988 mazda b2200 and i was sittin still runnin and it was a lil low in water and i was just ab to take off when it cut off. it made steam *** out the hood. the thing is its gettin eletric to the plugs and its gettin gas and i even tried a lil eather and its turnin over it just want crank. do u have a idea wat it could b? im thinkin it jump timeing.
Here is a link that will be very helpfull to you including what you need dont forget to rate my assistance thank you.http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?chapterTitle=Vacuum+Diagrams&partName=Driveability+%26+Emissions+Controls&pageId=0900c15280076be3&partId=0900c15280076b68
get spark tester and start testing from the spark plugs back. first hook it to aplug wire and check for spark if no spark ten hook it to the coil wire and check for spark if no spark then there is a chance that your coil or ignition module is bad if it is equipt with electronic ignition.
my 88 mazda b2200 will die unless you turn the idle screw almost all the way up, and when im driving at higher speeds the truck runs fine. sometimes it will just completely shut down on highway. the ignition switch also in was told needs replaced for other reasons, and i was wondering if this could be connected thank you
in most cases no.
×