I am assuming you are talking about the large bin at the bottom of the center console that normally rotates down when you open it - and then rotates up to close and spills some of the contents behind the bin never to be seen again...
To remove it, with the bin in a nearly closed position, simply pull the bin forward and it will 'unclip' - it seems like there are plastic hinges near the bottom that just clip in and out.
?€¢
The cruise control harness (if equipped)
?€¢
The forward lamp harness
?€¢
The SIR system harness
?€¢
The relay center
?€¢
Remove the manual transmission shift lever (if equipped).
?€¢
The Heating, Ventilation and Air Conditioning module (HVACM)
?€¢
The 22-way engine harness
?€¢
The stoplamp switch
?€¢
The vehicle speed sensor (VSS) calibrator module
?€¢
The clutch or brake release switches
?€¢
The electronic accelerator (Diesel)
?€¢
The HVAC control cables (if equipped)
4.2.
Disconnect the cables (if equipped).
Remove the instrument cluster screws and the cluster. Refer to Instrument Cluster Replacement .
Remove the IP storage compartment.
Squeeze the compartment in order to release the compartment.
Remove the IP storage compartment lamp.
Slide the compartment in order to release the compartment.
Remove the low coolant module (Diesel only). Remove the data link connector (DLC).
20.1.
Remove the one screw.
20.2.
Slide the DLC out.
Remove the harness retainer to accessory switches. Remove the fuse panel and the courtesy lamp switch. Remove the ground screw. Remove the harness from the IP. Remove the jumper harness to the remote playback device (if equipped). Remove the courtesy lamp switches. Remove the side window defogger outlets. Remove the park brake cable clips. Remove both of the air outlet deflectors
Removal & Installation
240 views
Usually answered in minutes!
×