Location of wiper control module 2000 crown victoria

that's because it's a wiper control module that I think your looking for what is happening anyway do they work at all ==yes/no only certain positions work===yes/no or won't shut off ===yes/no



that's it right here^^^^^^^^^^^^^^^ and the location is in the diagram above but you must check all the fuse/s first Google 1996 ford crown Victoria and download for free to your phone/computer that way you'll always have it then go to roadside emergencies and the passenger fuse box/power distribution box diagram under the hood are there and is needed for times when something happens on the road if your wipers stopped working because you tried to use them without clearing ice away or a big piece of ice got stuck in the cowl where the wipers are you blew the fuse if they work erratically or won't shut off or stop up on the window blocking your vision either the module shown above or the wiper transmission in the wiper motor has failed and must be replaced as a whole unit

See this pic .



if this doesn't help please visit this forum for full details.
ELECTRICAL Windshield Washer Motor Fuse Location Crownvic net

Look under your hood on the driver's side of the engine compartment. There a black box located on the fender well with a cover on it. Under the cover, is a diagram showing the position of each relay fuse.

If the sensor was the problem you would have a check engine light on, the fan is operated by the powertrain control module which controls a relay module. You must have the dealer run a scan of the system ans do an active test on the fan operation to determine what is wrong.

I suggest check position 2, 30A for Wiper Control Module, Windshield Wiper Motor...



Keep in mind that this and other important information could find in Ford Crown Victoria owners manual.

Hope this helps; just keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Have a nice day and thanks for using FixYa.

Jose.

Follow the Dark Blue/White wire or Brown/White wire from the Multifunction Switch to the wiper module according to the schematic.
Also, one can trace the wires from the windshield wiper motor to the wiper module by peeling away the wiring loom and looking for a Yellow/Red wire that leads to the module.
---
Windshield Wiper Motor Removal & Installation To Remove:

1. Remove the mounting arm and pivot shaft assembly.
2. Remove the windshield wiper motor cover.
3. Remove the clip.
4. Disconnect wiper transmission linkage.
5. Remove the bolts.
6. Remove the motor.

To Install:

1. Position the wiper motor.
2. Install bolts. Tighten to 10 Nm (89 in. lbs.).
3. Connect wiper transmission linkage.
4. Install clip.
5. Install wiper motor cover.
6. Install mounting and pivot shaft assembly.

There is no ignition module. The ignition coils are controlled directly by the Powertrain control module (computer) located inside the vehicle above the drivers left foot and connected to the engine wiring harness thru the firewall

i believe it is part of the wiper motor which should be located in the driver's side rear corner of the engine bay, on the firewall. Many 03 and up Fords use a "Smart motor" for the wipers which has the motor and a module in one piece.

here is a diagram

It could be the wiper control module.

hello jaronricky , the Powertrain Control Module (PCM) is located right next to the power brake booster . 2000 crown vic