Hyundai lantra 1997 sedan 1.8 ltr engine cutting off after short drive if engine hot or cold the same,after cutting off enfine immidate start and drive normaly,it's happen anytime. ple's help me find out this problem its grateful to u, thanks and regards manoj
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
the 2.7L is a V6, to perform a drive cycle you need 1/4 to 3/4 tank of fuel and do not exceed 59 mph for a good 10 to 20 miles and then a key cycle to check if it did not go try again . best when cold start up
1998 Hyundai Lantra "G4GM" engine 1795cc.there are two heads or blocks, one is called the M10, other is the M12, figure out which one you have cause the torque is different for stage one by 5nm...........
Dont get confused theres 2 different engines so 2 different torques for stage1---------
heres the full details: Stage 1 - m10 = 30nm / m12 = 35nm-------------------------- -------- Stage 2 - tighten by 60-65 degrees ------------ stage 3 - tighten by 60-65 degrees. no sequence is given in the data book for tightening so go off what you thinks right, it doesn't matter on this engine.
If the replacement thermostat is good, and installed properly, then the temp sensor might be bad. I hate to tell you ($$$$$) but waterpump could be bad (more expensive)
try pushing the clutch to the floor with you toes if it starts and won't unless you push to the floor its the clutch start switch 22 bucks at auto zone i will be gettng help installing the new one i will let you know.
×