I have a 2003 Ford Taurus. Was running and driving great. Was driving down the highway and the car quit going forward, Pulled over and shifted gears, the car will not move forward or backwards. Was running great before this. No signs of any transmission problems. Someone said it could be the moduator? Any answers or advice would be greatly appreciated
SOURCE: 2000 ford taurus- wont shift into gear
first check drive axels , since you replaced front springs on struts i assume. it is possible that one of the axels popped out. next if thats ok check fluid level in trans with eng OFF should show over full make a srcribe mark on the stick. then START the eng it should go down to full or just below depends if trans is full or a little low . if level does not drop approx.1/2 in or so then have a transmission shop check for bad splines in torque convertor, that is a comon problem in that car, year and milage do not play a roll a large roll in parts failure in trans any more. not like it use-to.
SOURCE: Automatic Tranmission forward gear works reverse doesn't
YOU HAVE A SHIFT SOLENOID THAT HAS EITHER FAILED OR IS STUCK, DO YOU HAVE ANY TRANS TROUBLE CODES?
SOURCE: Ford 2003 Windstar transmission problem
Windstar tranny problem: just got off phone with Northway Transmission of Queensbury, NY Technician said the torque converter had destroyed itself. the pump drive spline in converter broke and took out fins in torque converter it's going to cost me nearly $1600.00 car has only 45000mi on it and I caught it rather quickly and DID NOT TOW had car moved by flatbed/ramp truck otherwise they would have had to completly tear down transmission. (over $2300.00)
SOURCE: Transmission suddenly quit working
if the car doesn't move then the speedo would not move, right? or do u mean something else? yours trans has failed or the trans digital range selector switch is bad, have a scanner put on the system and see if any trouble codes are present.
SOURCE: Bucket seat shifts forward and backward
i had the same prob when i got my durango.i set the seat where i was cumfortable and still where my wife could be cumfortable drilled two small holes on the side of the rail and shot two rivets through it.all the other controls work the same but it doesnt go back and forth anymore.works for me ,alot cheeper than a power seat.
274 views
Usually answered in minutes!
×