How do you remove radio from hyundai accent 1998

SOURCE: how do i remove the radio from the dash 1998

Hi
You have to take out the ash tray, and remove those two screws, then pop out the center dash trim. Careful, though, you have to take out a lot of the wiring inside of your center dash trim in order to pull it out for enough room to move the radio in and out.
OR more elaborately try the following:-
1. Remove the panel under the steering wheel. There should be four bolts - the two at the top are covered with plastic caps. When you have removed the panel, take off the two climate control cables that run to the air controls on the dashboard. They should be secured with clips which need to come off, and the wire centre is wound around a small control knob which should have a push in clip so the wire can slip off.
2. Make the glove box drop down by removing the two plastic clips at the back of the inside of the glove box. These clips are the glove-box buffer stops and should spring off and can be pulled through the clip-opening. Behind the glove-box is another wire to un-clip, but this one slips straight off the metal control actuator.
3. Remove the ash-tray by pressing the spring loaded metal part down and take the two screws out at the back of the ash-tray. You should now be able to unclip the central dashboard. Use a screwdriver to lever it away gently, and watch for the small metal clips that drop out as you do so. As you pull it away the cables you unclipped will come away from their place and come out with the dash unit.
4. After pulling the dash-board out a few inches you should be able to see the seating screws for the radio. Take all the screws out and pull the radio forward. By unclipping the cables at the top of the unit you will find you have enough play to pull the driver's side right forward and jigger the head unit out of the gap on one side of the unit.

Thanks for contacting fixya.com