2004 trailblazer remove rear bumper - 2004 Chevrolet TrailBlazer

There's a website that has all this informatio n about all this and manuals everything totally free there are many actually but I personally like few . reliable-store
let me know if u need help
thanks

Chevrolet Trailblazer parts and accessories

lamborghini diablo rear bumper .how many hours to remove

1. Remove rear combination light assembly. A. Remove two mounting screws. B. Disconnect electrical connector from rear side of light assembly.

2. Remove bumper assembly. A. Remove four fasteners and four retaining screws from top of bumper assembly. B. Remove mud flap from bumper assembly. C. Remove two screws from bottom of bumper assembly. D. Remove two screws from side of bumper assembly. E. Remove four bumper mounting bolts from under of vehicle.
3. Install rear bumper in reverse order of removal.

I have written a detailed step-by-step tutorial on how to remove and replace the bumper of a 2004-2007 Toyota Sienna on my blog: John Fixes Stuff How to Remove the Front Bumper on 2004 2007 Toyota Sienna

1. Remove the screws that secure the license plate lamp assembly to the rear bumper fascia
2. Pull the license plate lamp assembly down and out through the mounting hole in the rear bumper fascia far enough to access and disconnect the wire harness connector.
3. Remove the license plate lamp assembly from the rear bumper fascia.

1. Open the trunk.
2. Remove the rear compartment sill plate. (Trim round the back edge of the trunk)
3. Pull the left and right compartment side trim panels down to access the fascia bolts and nuts.
4. Remove the tail lamps.
5. Remove the fascia bolts and nuts from the rear bumper fascia 1 nut 1 bolt on each side near tail lights.
6. Remove the push-in retainers from the top edge of the fascia.(4 plastic circles, pull up on center of cirle with screwdriver
7. Raise and support the vehicle.
8. From underneath Remove the push-in retainers from the rear bumper fascia (one on each side I think)
9. Remove the fascia bolts from the rear bumper fascia. on on each side from, up where the facia connects to the quater panel)
10. Remove the rear bumper fascia from the vehicle

you might be able to get to it by reaching up under the bumper. if there's a plastic shroud, you'll need to remove it. if not, you'll need to remove the bumper. it's a pain i know.

how do you remove a front bumper off of an jaguar s type?

Removal of the rear bumper on an Mazda 2004 to 2006 MPV.
It's afairly simple task: 1) Open the rear hatch or (door) remove the torx screws at the bottom of the weather strip. 2) Remove both tail lights by unscrewing the two phillip screws on each light, once removed the lights pulling toward the side of the van. Let them hang from the wires. You will see a clip (white in color),pry it out from behind the bumper material and go to the next step. 3) Remove three 8mm head screws in each fender well and three plastic clips. Then remove an 8mm screw at the top corner of the bumper against the rear fender. If your car has splash guards remove them as well. 4) Remove the two clips at the bottom of the bumper attached to the under carriage. 5) Pull the bumper toward the back of the vehicle be careful with the tail lights. Remember, they are hanging loose.
And that's it, you have done it.
Ferni