1993 Toyota Previa Logo

Related Topics:

Anonymous Posted on Aug 24, 2013

My Toyota previa 1993 reverse gear not working

3 Related Answers

skidoorev

skidoorev

  • 11 Answers
  • Posted on Mar 27, 2009

SOURCE: I can't find the fuel pump relay in a 1993 Toyota

The fuel pump relay is always one of these two places, either under the steering colum to the left of the break pedal in the fuse/relay box or it would be under the hood of the car on the driver side also in a fuse/relay box.

Ad

Anonymous

  • 1 Answer
  • Posted on Jan 17, 2010

SOURCE: 91 Toyota Previa AWD - Swap original engine for Previa Supercharged engine

I do a lot of work on Toyota Previa before; including rebuilt engine, swapping engine and transmission and lot of things in between, but never swap a normal aspirated engine to a supercharged engine or diesel. Since i have some experience in Previa, I would like to share my opinion with you regarding your plan to swapping the normal aspirated Previa engine to a Supercharged engine. When you do a swapp like that, you will not only be dealing with just swapping engine, but some wiring, computer, throttle body, air cleaner assembly, extra frame and pulley on the accessory items, transmission as well as a right rear end to get the correct gear ratio to accomodate the new engine and transmission. I can go on even more, but let me tell you this, beside less headache, it would definitely cheaper if you were to find a Supercharged Previa and fix it up. However, if you are totally motivated to do this project, keep in mind, this engine swap will be a long term and time consuming project.l I wish you best of luck and have fun!

Peter da techmen

  • 184 Answers
  • Posted on Feb 11, 2011

SOURCE: oil level light stays blinking on toyota previa

most of these models have 2 oil lights.The red one is oil pressure,if flashing or on when engine is running,it is usually serious.check oil level,but usually caused by blocked pickup screen(a common toyota fault) when services aren't done.The orange oil light is tripped by an oil level sensor on the side of the sump when the oil level is low.If the oil level is ok,note this is a common fault especially if oil changes have been missed,and/or a petrol engine oil used and sludge builds up,sometimes using an additive for flushing prior to oil change can help,but may not work on 1st oil change.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How to remove egr valve on a 1993 toyota previa

That previa has a central engine, so all engine work requires you take out driver and or front passenger seat out.

The EGR placement is here >> http://www.autozone.com/autozone/repairguides/Toyota-Previa-1991-1997-Repair-Information/EMISSION-CONTROLS/Exhaust-Gas-Recirculation-System/_/P-0900c1528008a1d5

near the bottom of the page.
Good luck
1helpful
1answer

My Toyota Previa after sitting for a few days takes about 3 minutes before reverse gear will work. Checked Automatic tranny oil when hot and is correct - forward gears work ok Thanks Graham

try to change the trans oil and filter possibly need to change, looks like a transmission shift solenoid is the problem or trans computer the oil and temperature will get it last longer also but would likely recommend to have it diagnose by a transmission specialist to fine what causing it
0helpful
1answer

Vault on automatic gear box on toyota estima enima

2.2td estima enima,the auto gearbox stopt change gear from 3 to 4,can somebody help me please?
1helpful
1answer

How much transmission fluid(oil) should a 1993 2.4 auto toyota previa gx hold in the gear box and cooling system in total !

There is always a guage there. Fill and use the guage to determine wat amount but do not exceed the guage line.

Don't forget to rate this fixya!
0helpful
1answer

Vault on automatic gear box on toyota estima enima

Normal reason for this because car is low on automatic transmisson fluid
0helpful
1answer

Pinion gear

ring and pinion. from dealer
0helpful
1answer

Previa, no heat on 1 and 2 gear

the blower motor resistor is bad.
Not finding what you are looking for?

134 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...