SOURCE: How do I remove the front door panel to replace the mirror
Normal
0
Disconnect your negative battery cable. Locate and remove
the screws that hold your interior door handles in place (they may be hidden by
snap in, or snap on clips). Remove the interior door handles, then disconnect
the wire clips to the switches. Your panel is held in place by snap in clips;
use a small pry bar to pull them from the door (try to get as close to, or
directly under the clips to prevent them from tearing out of the door panel).
Once the clips are pulled, pull the panel upward to remove it from the door.
Install in reverse.
If you don't have power windows you will have to
remove the manual window crank. It is held in place by a clip on the back side
of the base. To remove the clip, you will need a small hook (kind of like a
knitting needle). Put the hook in behind the base, and grab the clip and pull
it off. To replace it, slide the clip back on the window crank, and snap it
back on the door.
SOURCE: Instructions on how to remove a rear door panel
Firstly, if you don't know how...I doubt you can remove it anyway. Take it to your local car stereo installation shop and ask them NICELY to take it off - explain what the problem is (lemme guess the window/lock doesn't work).
Good Luck
SOURCE: Remove right rear door panel 2003 Buick LaSabre
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: how do i remove the rear passanger 2000buick lasabre door panel.
You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door
SOURCE: 94 LeSabre inner door panel removal
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls
1,391 views
Usually answered in minutes!
×