2000 jeep grand cherokee limited...radio shorts out, or odmeter flashes then abs lamp flashes, now check gauges light is coming on, alternator gauges drops and engines almost dies...is this the wiring harness problem or a ground proble?

SOURCE: the tail lights are out, so the brake lights-Jeep Grand Cherokee

i have a 2002 jeep grand cherokee i had the same problem when i would apply my brakes when the headlights were on my brake lights would go out, i found that my bulbsocket was not making good contact with the socket housing, if you notice when you take off a bulb, look at the light fixture where you unscrewed your breaklight bulb you will notice 3 medal contacts-they should be silver in the socket housing and like a copper on the socket bulb, in the socket housing their should be 2 silver contacts together and 1 by itself the one that looks by itself is making bad contact with the copper one thats by itself on the bulb, what you can do for a quick fix is; get a small piece of low cage wire or a thin piece of metal like copper stick that in to the bottom or top of that metal contact--i did it through the bottom leave the wire or piece of medal sticking out enough for where it can get contact with the bulb (just a little wire is enough to make contact, now screw the bulb on and test it---it will work----i did it to mine, if you need more assistance let me know [email protected]

SOURCE: 1997 Jeep Grand Cherokee Stalls when put in gear V8

Replace the throttle postioning sensor, and mass air flow sensor

SOURCE: 2000 Jeep Grand Cherokee Limited Fuel Filter

Sorry brother, it is in the gas tank with the pump. they used filters that are suppose to be good for the life of the vechicle. you can see the plug if you lift up your spare. hope you dont HAVE TO go in there.

SOURCE: In my 1996 jeep grand cherokee the oil pressure

might want to check the ignition control (the key) did same to me but with volt gauge

SOURCE: 2005 Jeep Grand Cherokee Limited, 5.7L V8, starter

Every morning at lunch time and evening my jeep won't start. It doesn't grind but the electrical goes crazy. After a couple of trys it finally starts. Help