Thank goodness it's up! No fuse found, don't know where to start, removing rear door panel? Anyone had this problem? Could it start on the drivers door panel? Please help if ya can. Thanks
Removal and Installation
NOTE: Lower the window to access the rivets.
Remove the two rivets retaining the rear door window glass to the rear door window glass run and bracket.
SOURCE: how remove the rear inside door panel on a 2001 oldmobile aurora
The inner door panel is held in by clips and screw.
Look at the door near the door handle there should be screws holding it in and along the outer edge of the door. Once loose, and the door handle removed or the arm rest removed. The door panel then prys out , because of the clips that hold it on. Then pops out by applying pressure to the panel upward to the top of the door. The clips always break because of the design and plastic.
Good luck
SOURCE: window dropped into rear door panel. How do I remove the panel & repair
the window regulator has failed. the door panel has to be removed first which requires removing the trim piece that is on the grab handle (extremely hard to remove without breaking) there are three of four screws that hold the door panel on. once the door panel is off, the vapor barrier has to be removed. don't tear it, it is there for a reason to keep water out of the vehicle. make sure you reseal it properly with window weld. once the vapor barrier is removed you will need to unclip the window glass from the regulator. i typically will take and break the tab that holds the window. once the window is loose, move the glass all the way to the top of the door. now remove the regulator, swap the motor over, and reassembly. i would recommend taking the vehicle to a bmw dealership, around $650 for the complete repair and the dealership will stand behind their repairs
SOURCE: how do you remove the rear side door panel to
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls
641 views
Usually answered in minutes!
I have the same problem with my rear window on the drivers side. Your solution is very vague.
×