Try locking all the doors and unlocking the hatch with the key.
SOURCE: CAN YOU TELL ME HOW TO USE A SLIM JIM TO UNLOCK JEEP GRAND CHEROKEE LAREDO. LOCKED KEYS IN CAR.
a slim jim is not a good ideal to be using in todays cars and trucks with airbags everywhere and wires inside doors..call a pro and if he pulls out a slim jim send him packin...there a re far better tools to use than a slim jim
SOURCE: can't unlock doors without alarm going off
If you lock the car from the outside with the key your alarm will not go off this happened to me too
good luck with buying a new keypad they're over 150 each
SOURCE: setting memory seats on 1997 grand cherokee with key fob
I had the same problem and had to kinda figure it out on my own. I have a 98 grand cherokee and I think they should be the same. Inside the drivers door panel there are 3 buttons... a number 1 and number 2 and a SET button. Hold down the set button for a couple seconds then release. Then adjust your settings on your seat and mirrors to what you want...Then press # 1. If you have another person that will be driving the car do the same and press number 2...
The thing is...........There are 2 key chain things issued with each car...One will be the number 1 driver, the other one is the number 2 driver...So...I would program the number 1 driver first and see which key chain thing works...then you will know the other one will be for the number 2 driver.
Hope that made sense...It is a great feature once you finally figure it out. Sheri
SOURCE: How do you program a 2002 Jeep Grand Cherokee FOB?
if you have an original working fob and your owner's manual,it will explain procedure,otherwise will have to go to dealer to be programmed
SOURCE: Can not disarm alarm on 2002 jeep grand cherokee
First, try to re-programme the RKE (Remote Keyless Entry) transmitters before searching for anything else. Assure that the batteries in the transmitters are in working condition and replace them if you are not sure. To pro-gramme the transmitters, perform the following:
Open the driver's door and let it be open throughout the programming process. Then, shift the mechanical door lock lever to the LOCK mode, turn the ignition key to the rUN mode. Within a period of twenty seconds, point a transmitter at the receiver dome and push the lock button for a period of five seconds at least. After the receiver has accepted the programming code the driver's door will unlock on its own. The first transmitter has been programmed, in the same extra transmitters up to four may be programmed in the same way, within twenty seconds.
If the alarm does not work
properly, you may have a faulty alarm module and may have to be replace and its common problems with and older model. the systems work like a security systems, if you arms your system with the remote you have to disarm it also with the remote in order for the engine to start and run. The logic in the PCM prevents the VTSS engine no-run feature from arming until the engine start; Its one of the security systems jeep has and if you ask for my opinion its junk. hope that help some..
1,190 views
Usually answered in minutes!
×