- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I'm assuming brake LINE diagram? Seems like there should be one in the repair manual however those usually just run from the master cylinder and can be traced visually. Maybe you could clarify you're question.
That would be in the owners manual, we do not have that because BWM doesn't allow free downloads of their manuals. Try eBay for used one or buy from the dealer.
Depends on why the brakes are not working. The only reason you would have to bleed brakes is if air got into the brake lines and the only way air can get into the brake lines is if the master cyl went dry, which means you have a leak somewhere or someone made a repair and removed a line, which will allow air to enter the system. Other than that the brakes could be severly worn.
The "brake lining" means your brake pads( on one axle) have worn to its service minimums and will need to be replaced soon. Have your brakes serviced. continued operation can cause brake rotors to become damaged from metal to metal contact.
The incorrect fuel gauge reading could be caused by several causes, but most likely a worn out fuel level sending unit.
I can't show you a picture of brake lining wear but I can explain what it is. Brake lining wear is your brake pad wear. If the instrument cluster is showing "brake lining wear' ' visit workshop' it means your brake pads have worn down and are now at the brake pad wear sensor.
code 22 is a problem at coolant temp.sensor voltage too high or too low,the brake warning light could mean that fluid is low and u have a lost of pressure,brake line leak,leaking rear brake cylinder,worned out brakes,defective master cylinder or a defective handbrake and the switch stays on.youll have to check brake system!
press the satrt button with foor off the brake until lights turn on,close the doors and press and hold the trip button on the inst cluster,abs will come up and then go,than you will see all the diff cbs requirements on left side press button until the brakes come up and press and hold again, it should reset to ???tkm
×