The passanger side window will not roll up so i need to remove the panel and so it manually
SOURCE: change drivers side door panel on 94 chevy p.u.
unscrew the inside handle and pop of the window arm....then slowly work your way around the panel poping loose the plastic rivits on the inside edge...lift panel upwards to unhang it from window lip...thats the plastic panel...the metal panel inside that is pretty self explanitory..unscrew and take off the clips holding the controle arms to it and remove...do use caution as parts are very sharp and will slice your fingers and hands.
SOURCE: Need to repair passenger side window--2002 Tahoe.
take every crew that you see on the door panel out. (the arm rest screws) and when you have done that there are just plastic clips on the back holding the panel on just be careful pulling on the panel because the clips like to break.
SOURCE: replace 1994 chevy camaro window motors
the best thing that u can do is go to the store and buy the repair manual for your car they usually run between $15 and $20 and they will have step by step instructions and pics....not only is it good for this but pretty much anything else u want to know about ur car..hope this helped
SOURCE: need to remove manual window handle to get door
There's a special tool designed to release the lock ring behind the crank. The tool slips in between the door and crank and releases it. You could also use two metal objects to push on both ends of the opening to pop the pin out. This pin will go flying when it pops off. You can also take an old terry cloth towel and slip the hemmed or finished edge between the crank handle and the door and slide it back and forth with an upward pressure. The towel will catch on the points of the locking ring and pop it right off.
SOURCE: How do I remove the door panel on a 01 Camaro?
carefully remove the electric window and lock assembly from door pull. take screws out of under door pull and to the bottom rear on the panel the lock assembly is in. around the sides from the middle around the bottom and up the other end by prying with a screw driver or thin flat sturdy piece of metal. once all the plugs are ouyt lift the panel up, it fits tite on the top of the door along the window. pull away from door a short distance and unhook speaker plugs . you can work the switch assembly thru its hole without unhooking wires.I forgot to say at first pull the lock slide forward till it pops off the rod its stuck on. that'll be the last thing when you finish. I may have forgotten a screw or so buut it'll be easy to notice. randy austin tx [email protected]
169 views
Usually answered in minutes!
×