SOURCE: LEFT TRAILER TURN SIGNAL DOES NOT WORK
I'd get a 12vdc test light if you don't have one already & start from plug, and keep probing back from there. It may be as simple as a bad connection under truck where joined into harness.
SOURCE: factory 99 dodge trailer plug wiring
You'll need to disconnect the wires from either the truck connector or the trailer connector...
I highly suggest purchasing a voltage checker- it looks like a screwdriver with a pigtail of wire with an alligator clip on the end. The tip of the 'screwdriver' has a point for probing. The light in the probe will light up...makes it easy to trouble shoot without a helper behind the trailer.
Hook the aligator clip to a good positive grounding point on the bumper or frame(not painted).
then pin by pin on the truck connection, stick the probe on each terminal tab.. and write a simple diagram where you find brake, tail, backup, etc...
Then i'd suggest, taking the connector off of your trailer, exposing the wire ends.
Run again thru your diagram and turn on each light of the truck. As you do, touch the wires from the trailer to that specific terminal. (make sure your ground wire is attached on the trailer) you can mark each wire with a piece of tape and label it which is which.
then simply attach your trailer wires according to your diagram to the terminals in the connector... that should get you in business..
hope that makes sense...
That way if the factory wiring harness remains the same, you'll be able to use it with other trailers if the need arises..
SOURCE: No power to tail light on trailer- 2004 Dodge durango factory tow
If this is a factory light harness for the trailer hookup on your Caravan. Look under the hood for a fuse box. Many 2000+ vehicles have this with separate fuses just for the trailer lights.
SOURCE: Trailer hitch...no running lights (2004)
You'll have to follow the BROWN wire from the factory connector(with the running lights on of course) to the trailer connector and make sure you are getting power all the way to the two lamp fixtures. If so you've probably got two burned out 1157 bulbs or an inline fuse in the factory harness/ trailer harness.Good Luck, Dana
SOURCE: LEFT TRAILER TURN SIGNAL DOES NOT WORK
I have seen once before that the fuse box was bad on a 2003 Dodge 3500. I had power in and nothing out. We had to replace the box. Not cheap! Hope it is simple like a loose connection though. I think I had to pull the inner fender on the drivers side to access the bottom of the fuse box. Pain in the ****, but...
618 views
Usually answered in minutes!
×