Brake lights stay on 2001 chevy s 10

Your flasher is buzzing because it's a piezo instead of a flasher. I don't know how that would have been connected, but it is. Replace it with a flasher. The E brake light is on because the pull handle is still out just enough to connect it or it stays on because the antilock brake light is lit. Your dash and run lights have a blown fuse, headlights are on a separate fuse is why they still work. Water leaking from the roof shouldn't effect the electrical circuits, but most likely you have a wire or so crossed in the system.

Hazards work only when lights are off. Left signal light stays lit on the dash and does not blink and is stuck on (lit up) when lights are lit. If I place hazards on while lights are on only right side flashes and whole dash lights flash too... I replaced the flasher relay and it still does not work. Suggestions anyone? Thanks!

on your brake pedal there is a switch that controls your brake lights over time it comes to lose just enough for the switch won't come in contact with the pedal

The hazard flasher is a separate flasher by itself for the directional has its own. The brake lights work off the brake light switch mounted by the brake pedal

Try the flasher unit inside the fuse box... I cant remember, but some cars have different unit for signals and hazard lights...

its your blinker box.. all major lights run through there

behind the radio, take the radio and the cover that goes over it. it should be there next to the hazard ligths flasher.

flasher located at bottom of fuse box its round bout the size of a pop bottle lid,hazard flasher located at top

Please locate the fuse in the fuse box. there must be a failure from there. Take the car for a scan too.

Please rate this......

The problem is the turn signal/headlight/hazard switch assembly on the steering column which the brake light wiring runs through. The part is easy to change and cost about $50 at most parts stores