SOURCE: replaced clutch slave cylinder blew
Could be a couple of different things.
1) your clutch master has a plugged pressure bypass, and it is sending excessive pressure to the slave and blowing it out.
2) The clutch throw out arm is bound, and will not allow the slave to compress it.
3) The replacement slave was defective.
What was the reason for replacing the slave in the first place?
SOURCE: Bleeding clutch slave cylinder
i think youre doing the right thing. they are very stubborn to bleed because the hyd. line goes up high across back of engine before droppiing back down to slave cyl., trapping air. could try to gravity bleed by opening bleeder at slave, cap off of master cyl, full with fluid then it may start to come out after a bit. then try your process again. or can try to bleed at connections further up the line, working your way back to bleeder. hope this helps. be patient.
SOURCE: im trying to replace a clutch slave cylinder in a ford focus
hi there to replace your clutch slave cylinder you will have to remove your gear box as it is bolted into gearbox.
SOURCE: Bleeding Clutch Cylinder with no bleeder screw
I have not tried myself but see if the link below will work for your case. It is not the same model as you have but most vehicles have the same components for the non electronic parts. http://www.2carpros.com/forum/1988-dodge-dakota--bleding-air-out-of-clutch-master-cylinder-vt248517.html
SOURCE: 1999 pontiac sunfire bleeding clutch
my 1999 pontiac sunfire drivers door latch is broke can not close the door. i have it pulled shut? how much will a used latch cost, or even 3 bolts for it? all the auto stores/ jumk yards are closed for me to call
137 views
Usually answered in minutes!
×